This patch adds missing pinmux setup for 4 GPIO signals used on the Beagle xM:
- USB hub reset (gpio_56)
- P8 USB hub reset (gpio_63)
- DVI enable (gpio_129)
- P8 DVI enable (gpio_170)
Signed-off-by: Steve Sakoman <st...@sakoman.com>
---
board/ti/beagle/beagle.h | 4 ++++
1 files changed, 4 insertions(+), 0 deletions(-)
diff --git a/board/ti/beagle/beagle.h b/board/ti/beagle/beagle.h
index d860337..f0ca468 100644
--- a/board/ti/beagle/beagle.h
+++ b/board/ti/beagle/beagle.h
@@ -386,6 +386,10 @@ const omap3_sysinfo sysinfo = {
MUX_VAL(CP(UART2_TX), (IDIS | PTD | DIS | M0)) /*UART2_TX*/
#define MUX_BEAGLE_XM() \
+ MUX_VAL(CP(GPMC_NCS5), (IDIS | PTD | EN | M4)) /*GPIO_56*/\
+ MUX_VAL(CP(GPMC_WAIT0), (IDIS | PTU | EN | M4)) /*GPIO_63*/\
+ MUX_VAL(CP(MMC1_DAT7), (IDIS | PTU | EN | M4)) /*GPIO_129*/\
+ MUX_VAL(CP(HDQ_SIO), (IDIS | PTU | EN | M4)) /*GPIO_170*/\
MUX_VAL(CP(MCBSP3_DX), (IEN | PTD | DIS | M4)) /*GPIO_140*/\
MUX_VAL(CP(MCBSP3_DR), (IEN | PTD | DIS | M4)) /*GPIO_142*/\
MUX_VAL(CP(MCBSP3_CLKX), (IEN | PTD | DIS | M4)) /*GPIO_141*/\
--
1.7.0.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
