<r...@andestech.com> 於 2020年11月4日 週三 上午10:01寫道: > > > > -----Original Message----- > From: U-Boot [mailto:u-boot-boun...@lists.denx.de] On Behalf Of Sean Anderson > Sent: Friday, October 23, 2020 9:30 PM > To: u-boot@lists.denx.de > Cc: Bin Meng; Marek Vasut; Jagan Teki; Simon Glass; Heinrich Schuchardt > Subject: Re: [PATCH v4 0/7] wdt: Add support for watchdogs on Kendryte K210 > > > On 10/1/20 10:56 AM, Sean Anderson wrote: > > On 9/9/20 5:04 PM, Sean Anderson wrote: > >> This series depends on > >> https://patchwork.ozlabs.org/project/uboot/list/?series=200642 > >> > >> Changes in v4: > >> - Fix build error without CONFIG_CLK > >> > >> Changes in v3: > >> - Note dependency on "time: Fix get_ticks being non-monotonic" > >> - Add a few signed-off-bys which were sent for version 1 > >> > >> Changes in v2: > >> - Fix fls being off-by-one when compared to log_2_n_round_up > >> - Move watchdog enable to k210.dtsi as it does not depend on anything > >> board-specific. > >> > >> Sean Anderson (7): > >> wdt: dw: Switch to using fls for log2 > >> wdt: dw: Switch to if(CONFIG()) instead of using #if > >> wdt: dw: Fix clock rate being off by 1000 > >> wdt: dw: Enable the clock before using it > >> wdt: dw: Free the clock on error > >> riscv: Add watchdog bindings for the k210 > >> riscv: Enable watchdog for the k210 > >> > >> arch/riscv/dts/k210.dtsi | 1 - > >> board/sipeed/maix/Kconfig | 2 ++ > >> drivers/watchdog/designware_wdt.c | 39 ++++++++++++++++++++----------- > >> 3 files changed, 27 insertions(+), 15 deletions(-) > >> > > > > *ping* > > > > Marek can these go into -next? > > > > --Sean > > > > *second ping* > > It appears that an earlier version of this series [1] was assigned to > Marek Vasut, but that the current version is assigned to Rick Chen. v2 > should be marked as superseded. Can this get picked up for the merge > window?
Those patchs seem have been reviewed and tagged. If no other comments furthermore. I can help to pull via riscv tree later. But it shall sync to master again: Applying: wdt: dw: Switch to using fls for log2 Applying: wdt: dw: Switch to if(CONFIG()) instead of using #if Applying: wdt: dw: Fix clock rate being off by 1000 error: patch failed: drivers/watchdog/designware_wdt.c:129 error: drivers/watchdog/designware_wdt.c: patch does not apply Patch failed at 0003 wdt: dw: Fix clock rate being off by 1000 Thanks, Rick > > --Sean > > [1] https://patchwork.ozlabs.org/project/uboot/list/?series=194673 > [2] https://patchwork.ozlabs.org/project/uboot/list/?series=200657