From: Dennis Gilmore <den...@ausil.us>
SATA and UART ClearFog imaages are not buildable as ENV_SECT_SIZE is not defined
set values for both possible targets
Signed-off-by: Dennis Gilmore <den...@ausil.us>
---
board/solidrun/clearfog/Kconfig | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/board/solidrun/clearfog/Kconfig b/board/solidrun/clearfog/Kconfig
index e8c3f53d84..cf95258090 100644
--- a/board/solidrun/clearfog/Kconfig
+++ b/board/solidrun/clearfog/Kconfig
@@ -50,9 +50,9 @@ config ENV_OFFSET
config ENV_SECT_SIZE
hex "Environment Sector-Size"
# Use SPI flash erase block size of 4 KiB
- default 0x1000 if MVEBU_SPL_BOOT_DEVICE_SPI
+ default 0x1000 if MVEBU_SPL_BOOT_DEVICE_SPI ||
MVEBU_SPL_BOOT_DEVICE_SATA
# Use optimistic 64 KiB erase block, will vary between actual media
- default 0x10000 if MVEBU_SPL_BOOT_DEVICE_MMC
+ default 0x10000 if MVEBU_SPL_BOOT_DEVICE_MMC ||
MVEBU_SPL_BOOT_DEVICE_UART
config SYS_SPI_U_BOOT_OFFS
hex "address of u-boot payload in SPI flash"
--
2.28.0
