On 12/21/20 12:43 PM, Sughosh Ganu wrote:
On the qemu arm platform, the virtio devices are initialised in
board_init, which gets called before the initr_pci. With this, the
virtio block devices on the pci bus are not initialised. Move the
initialisation of virtio devices to board_late_init which gets called
after the call to initr_pci.
Signed-off-by: Sughosh Ganu <sughosh.g...@linaro.org>
With which commands can I see the difference before and after the patch?
Best regards
Heinrich
---
Changes since V1:
* The earlier patch was adding a call to pci_init in board_init. Moved
the virtio_init call to board_late_init
board/emulation/qemu-arm/qemu-arm.c | 5 +++++
configs/qemu_arm64_defconfig | 1 +
2 files changed, 6 insertions(+)
diff --git a/board/emulation/qemu-arm/qemu-arm.c
b/board/emulation/qemu-arm/qemu-arm.c
index f18f2ed7da..aa68bef469 100644
--- a/board/emulation/qemu-arm/qemu-arm.c
+++ b/board/emulation/qemu-arm/qemu-arm.c
@@ -64,6 +64,11 @@ struct mm_region *mem_map = qemu_arm64_mem_map;
#endif
int board_init(void)
+{
+ return 0;
+}
+
+int board_late_init(void)
{
/*
* Make sure virtio bus is enumerated so that peripherals
diff --git a/configs/qemu_arm64_defconfig b/configs/qemu_arm64_defconfig
index f6e586627a..5c855fa08c 100644
--- a/configs/qemu_arm64_defconfig
+++ b/configs/qemu_arm64_defconfig
@@ -14,6 +14,7 @@ CONFIG_LEGACY_IMAGE_FORMAT=y
CONFIG_USE_PREBOOT=y
# CONFIG_DISPLAY_CPUINFO is not set
# CONFIG_DISPLAY_BOARDINFO is not set
+CONFIG_BOARD_LATE_INIT=y
CONFIG_PCI_INIT_R=y
CONFIG_CMD_BOOTEFI_SELFTEST=y
CONFIG_CMD_NVEDIT_EFI=y
