On 15.01.2021 14:26, Padmarao Begari wrote:
> Hi Eugen,
> 
> On Fri, Jan 15, 2021 at 1:34 PM <eugen.hris...@microchip.com 
> <mailto:eugen.hris...@microchip.com>> wrote:
> 
>     On 15.01.2021 06:02, Padmarao Begari wrote:
>      > Hi Eugen,
>      >
>      > On Thu, Jan 14, 2021 at 4:50 PM <eugen.hris...@microchip.com
>     <mailto:eugen.hris...@microchip.com>
>      > <mailto:eugen.hris...@microchip.com
>     <mailto:eugen.hris...@microchip.com>>> wrote:
>      >
>      >     On 17.12.2020 07:22, Padmarao Begari - I30397 wrote:
>      >      > Hi Eugen,
>      >      >
>      >      > This series of patches break my side of work(patches) so
>     you need to
>      >      > create patches after my patches are going into master branch
>      >     because my
>      >      > patches are already reviewed and tested.
>      >
>      >     Hi,
>      >
>      >     Could you please detail the breakage ?
>      >
>      >
>      > The breakage is the fdt relocation disabled in the board environment
>      > variables so I have removed it and enabled fdt relocation in
>     PATCH v9.
> 
>     Maybe you misunderstand my question. I was asking about the sama7g5
>     macb
>     series, which you claimed that breaks your current patch set.
>     This is a link to the series :
>     https://patchwork.ozlabs.org/project/uboot/list/?series=218367
> 
>     Since you claimed that this series breaks your series, I am asking what
>     exactly is the breakage. How does the fdt relocation in your board
>     environment has anything to do with macb and these patches which are
>     not
>     applied ?
> 
> 
> My mistake, misunderstood your question,
> Yes the fdt relocation has nothing to do with the macb.
> We both are adding a member into struct mac_config, a dummy descriptor 
> for RBQP and my changes are both 32-bit and 64-bit DMA.

Okay, so, could you please tell me why you told us that our sama7g5 
series breaks your solarfire SoC series ?
It would be good for both of us if you could test our sama7g5 series on 
top of your patches, on your platform, such that we know that we do not 
affect anything on your board.

Thanks again,
Eugen

> 
> Regards
> Padmarao
> 
>     Thanks,
>     Eugen
> 
>      >
>      > Regards
>      > Padmarao
>      >
>      >     I saw a pull request with your patches that was NAK-ed, if
>     your two
>      >     macb
>      >     patches are tested and reviewed I could apply them to the
>     atmel tree as
>      >     well and send them, if your PR is delayed. But we are
>     interested to
>      >     have
>      >     our sama7g5 series pushed as well, so we need to know if it's
>     ok on
>      >     your
>      >     side, and what is wrong with the sama7g5 series.
>      >
>      >     Thanks!
>      >     Eugen
>      >      >
>      >      > Regards
>      >      > Padmarao
>      >      >
>      >   
>       ------------------------------------------------------------------------
>      >      > *From:* Eugen Hristev - M18282
>     <eugen.hris...@microchip.com <mailto:eugen.hris...@microchip.com>
>      >     <mailto:eugen.hris...@microchip.com
>     <mailto:eugen.hris...@microchip.com>>>
>      >      > *Sent:* Wednesday, December 16, 2020 12:24 PM
>      >      > *To:* anup.pa...@wdc.com <mailto:anup.pa...@wdc.com>
>     <mailto:anup.pa...@wdc.com <mailto:anup.pa...@wdc.com>>
>      >     <anup.pa...@wdc.com <mailto:anup.pa...@wdc.com>
>     <mailto:anup.pa...@wdc.com <mailto:anup.pa...@wdc.com>>>;
>      > bin.m...@windriver.com <mailto:bin.m...@windriver.com>
>     <mailto:bin.m...@windriver.com <mailto:bin.m...@windriver.com>>
>      >      > <bin.m...@windriver.com <mailto:bin.m...@windriver.com>
>     <mailto:bin.m...@windriver.com <mailto:bin.m...@windriver.com>>>;
>      >     Padmarao Begari - I30397
>      >      > <padmarao.beg...@microchip.com
>     <mailto:padmarao.beg...@microchip.com>
>      >     <mailto:padmarao.beg...@microchip.com
>     <mailto:padmarao.beg...@microchip.com>>>
>      >      > *Cc:* Claudiu Beznea - M18063
>     <claudiu.bez...@microchip.com <mailto:claudiu.bez...@microchip.com>
>      >     <mailto:claudiu.bez...@microchip.com
>     <mailto:claudiu.bez...@microchip.com>>>;
>      >      > joe.hershber...@ni.com <mailto:joe.hershber...@ni.com>
>     <mailto:joe.hershber...@ni.com <mailto:joe.hershber...@ni.com>>
>      >     <joe.hershber...@ni.com <mailto:joe.hershber...@ni.com>
>     <mailto:joe.hershber...@ni.com <mailto:joe.hershber...@ni.com>>>;
>      > u-boot@lists.denx.de <mailto:u-boot@lists.denx.de>
>     <mailto:u-boot@lists.denx.de <mailto:u-boot@lists.denx.de>>
>      >      > <u-boot@lists.denx.de <mailto:u-boot@lists.denx.de>
>     <mailto:u-boot@lists.denx.de <mailto:u-boot@lists.denx.de>>>
>      >      > *Subject:* Re: [PATCH 1/6] net: macb: use dummy descriptor
>     for RBQP
>      >      > On 03.12.2020 11:25, Claudiu Beznea wrote:
>      >      >> In case of multiple queues on RX side the queue scheduler
>      >      >> will try to use all the available configured queues (with
>      >      >> descriptors having TX_USED bit cleared). If at least one RBQP
>      >      >> points to a descriptor with a valid used bit
>     configuration then
>      >      >> the reception may block as this may point to any memory.
>     To avoid
>      >      >> this scenario all the queues (except queue zero) were
>     disabled by
>      >      >> setting DMA descriptors with used bit set on proper RBQP.
>     The driver
>      >      >> anyway uses only queue 0 for TX/RX.
>      >      >>
>      >      >> Signed-off-by: Claudiu Beznea
>     <claudiu.bez...@microchip.com <mailto:claudiu.bez...@microchip.com>
>      >     <mailto:claudiu.bez...@microchip.com
>     <mailto:claudiu.bez...@microchip.com>>>
>      >      >> ---
>      >      >
>      >      > Hi Anup, Bin, Padmarao,
>      >      >
>      >      > I noticed on the mailing list that you have been actively
>     working and
>      >      > testing the Macb driver on various platforms, we have this
>     series
>      >      > outstanding and I want to make sure that it does not break
>      >     anything on
>      >      > your side, so it would be appreciated if you could have a
>     look or
>      >     test
>      >      > it before it goes into master branch.
>      >      >
>      >      > Thanks !
>      >      > Eugen
>      >      >
>      >      >
>      >      >>   drivers/net/macb.c | 4 +++-
>      >      >>   drivers/net/macb.h | 2 ++
>      >      >>   2 files changed, 5 insertions(+), 1 deletion(-)
>      >      >>
>      >      >> diff --git a/drivers/net/macb.c b/drivers/net/macb.c
>      >      >> index b80a259ff757..836eb85ec96a 100644
>      >      >> --- a/drivers/net/macb.c
>      >      >> +++ b/drivers/net/macb.c
>      >      >> @@ -732,8 +732,10 @@ static int gmac_init_multi_queues(struct
>      >     macb_device *macb)
>      >      >>        flush_dcache_range(macb->dummy_desc_dma,
>      >     macb->dummy_desc_dma +
>      >      >>                        ALIGN(MACB_TX_DUMMY_DMA_DESC_SIZE,
>      >     PKTALIGN));
>      >      >>
>      >      >> -     for (i = 1; i < num_queues; i++)
>      >      >> +     for (i = 1; i < num_queues; i++) {
>      >      >>                gem_writel_queue_TBQP(macb,
>     macb->dummy_desc_dma,
>      >     i - 1);
>      >      >> +             gem_writel_queue_RBQP(macb,
>     macb->dummy_desc_dma,
>      >     i - 1);
>      >      >> +     }
>      >      >>
>      >      >>        return 0;
>      >      >>   }
>      >      >> diff --git a/drivers/net/macb.h b/drivers/net/macb.h
>      >      >> index 9b16383eba46..28c7fe306883 100644
>      >      >> --- a/drivers/net/macb.h
>      >      >> +++ b/drivers/net/macb.h
>      >      >> @@ -768,5 +768,7 @@
>      >      >>   #define GEM_RX_CSUM_CHECKED_MASK            2
>      >      >>   #define gem_writel_queue_TBQP(port, value,
>     queue_num)       \
>      >      >>        writel((value), (port)->regs + GEM_TBQP(queue_num))
>      >      >> +#define gem_writel_queue_RBQP(port, value,
>     queue_num)        \
>      >      >> +     writel((value), (port)->regs + GEM_RBQP(queue_num))
>      >      >>
>      >      >>   #endif /* __DRIVERS_MACB_H__ */
>      >      >>
>      >      >
>      >
> 

Reply via email to