On 2/6/21 4:45 PM, Pali Rohár wrote:
On Saturday 06 February 2021 16:40:18 Marek Vasut wrote:
On 2/5/21 8:12 PM, Pali Rohár wrote:
Function lowlevel_init() is called only from cpu_init_crit() and this
function is wrapped into #if .. #endif section. So compile also
lowlevel_init() function under same #if condition.
Signed-off-by: Pali Rohár <p...@kernel.org>
---
arch/arm/mach-omap2/omap3/lowlevel_init.S | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)
diff --git a/arch/arm/mach-omap2/omap3/lowlevel_init.S
b/arch/arm/mach-omap2/omap3/lowlevel_init.S
index 2a05b5e521..4fa89418a1 100644
--- a/arch/arm/mach-omap2/omap3/lowlevel_init.S
+++ b/arch/arm/mach-omap2/omap3/lowlevel_init.S
@@ -45,7 +45,7 @@ ENDPROC(do_omap3_emu_romcode_call)
ENTRY(cpy_clk_code)
/* Copy DPLL code into SRAM */
adr r0, go_to_speed /* copy from start of go_to_speed... */
- adr r2, lowlevel_init /* ... up to start of low_level_init */
+ adr r2, go_to_speed_end /* ... up to start of go_to_speed_end */
next2:
ldmia r0!, {r3 - r10} /* copy from source address [r0] */
stmia r1!, {r3 - r10} /* copy to target address [r1] */
@@ -167,8 +167,11 @@ pll_div_add5:
pll_div_val5:
.word CLSEL1_EMU_VAL
+go_to_speed_end:
#endif
This hunk above seems like an unrelated change ^ ?
Entry 'lowlevel_init' is defined 3 lines below and is available only
when !CONFIG_SKIP_LOWLEVEL_INIT && !CONFIG_SKIP_LOWLEVEL_INIT_ONLY.
Few lines above is code which copies DPLL code into SRAM and this code
ends at address where 'lowlevel_init' entry starts.
Entry 'cpy_clk_code' is compiled also when CONFIG_SKIP_LOWLEVEL_INIT is
defined, therefore it is required to define label which is outside of
the #if code defined below and ends after the 'go_to_speed' code.
So I defined a new 'go_to_speed_end' label to allow compiling
'cpy_clk_code' entry when CONFIG_SKIP_LOWLEVEL_INIT is defined.
Can you add exactly this description to the commit message -- the change
isn't immediately obviously, collect the RBs and resend the patchset, so
it can be picked ?
Thanks
