On 28.01.2021 10:14, Eugen Hristev wrote: > If the serial tx/rx are floating, it can happen that bogus characters > are detected on the line at boot time. This leads to U-boot accidentally > thinking someone pressed a key to stop autoboot, thus stopping booting > process. > This can happen if the serial cable is not connected. There are hardware > pull-ups on the board connected to serial cable VBUS. > To solve this when the cable is not plugged, enable internal pull-ups as well > for the tx/rx lines. > > Signed-off-by: Eugen Hristev <eugen.hris...@microchip.com> > --- > arch/arm/dts/sama7g5ek.dts | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/arch/arm/dts/sama7g5ek.dts b/arch/arm/dts/sama7g5ek.dts > index ff9c9eb45c..3a4fdd38a5 100644 > --- a/arch/arm/dts/sama7g5ek.dts > +++ b/arch/arm/dts/sama7g5ek.dts > @@ -122,7 +122,7 @@ > pinctrl_flx3_default: flx3_default { > pinmux = <PIN_PD16__FLEXCOM3_IO0>, > <PIN_PD17__FLEXCOM3_IO1>; > - bias-disable; > + bias-pull-up; > }; > > pinctrl_sdmmc0_cmd_data_default: sdmmc0_cmd_data_default { >
Applied to u-boot-atmel/master