On Thursday, October 14, 2010, wind_embedded <wind_embed...@sina.com> wrote: > > > well, when you completely ignore all good advice, including to ignore > known-to-be working code, and instead insist on using versions that > are > 3 years old and hopelessly obsoleted... > > ..then you must face the fact that you cannot get much help from the > community. > > > Update to recent code (v2010.09 at least), and use the generic CFI > driver. > > If you then should still have problems please feel free to ask again. > > Best regards, > > Wolfgang Denk > > -- > DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel > HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany > Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de > A list is only as strong as its weakest link. -- Don Knuth > > Dear Wolfgang Denk: > I have enable u-boot working on version u-boot1-1.1.4 and latest
Do you mean you are using 1.1.4 or do you mean you are using the latest version from the git repository? > version. I found the problem is the time interval between writing and > reading flash. The question is very strange, the CPU configuration of Are you using the CFI driver or a custom driver which uses time delays? > VxWorks is same as u-boot, flash driver on VxWorks is good, but bad on > u-boot. > Whatever thank you very much;) I repeat: Using the CFI driver and the latest version of U-Boot, this flash works without issue. Look at the eNET board for guidance Regards Graeme _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot