From: Tero Kristo <t-kri...@ti.com>
If the raw PM support is built in, we are operating in the split
firmware approach mode where RM and PM support is not available. In this
case, skip the board config for these two.
Signed-off-by: Tero Kristo <t-kri...@ti.com>
Signed-off-by: Tero Kristo <kri...@kernel.org>
---
arch/arm/mach-k3/sysfw-loader.c | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/arch/arm/mach-k3/sysfw-loader.c b/arch/arm/mach-k3/sysfw-loader.c
index 0bacfc4d07..64472353c4 100644
--- a/arch/arm/mach-k3/sysfw-loader.c
+++ b/arch/arm/mach-k3/sysfw-loader.c
@@ -159,11 +159,13 @@ static void k3_sysfw_configure_using_fit(void *fit,
ret);
/* Apply power/clock (PM) specific configuration to SYSFW */
+#ifndef CONFIG_K3_DM_FW
ret = board_ops->board_config_pm(ti_sci,
(u64)(u32)cfg_fragment_addr,
(u32)cfg_fragment_size);
if (ret)
panic("Failed to set board PM configuration (%d)\n", ret);
+#endif
/* Extract resource management (RM) specific configuration from FIT */
ret = fit_get_data_by_name(fit, images, SYSFW_CFG_RM,
@@ -172,12 +174,14 @@ static void k3_sysfw_configure_using_fit(void *fit,
panic("Error accessing %s node in FIT (%d)\n", SYSFW_CFG_RM,
ret);
+#ifndef CONFIG_K3_DM_FW
/* Apply resource management (RM) configuration to SYSFW */
ret = board_ops->board_config_rm(ti_sci,
(u64)(u32)cfg_fragment_addr,
(u32)cfg_fragment_size);
if (ret)
panic("Failed to set board RM configuration (%d)\n", ret);
+#endif
/* Extract security specific configuration from FIT */
ret = fit_get_data_by_name(fit, images, SYSFW_CFG_SEC,
--
2.17.1
