On 5/25/21 8:30 AM, Andre Przywara wrote:
> At the moment the Allwinner MMC driver parses the bus-width and
> non-removable DT properties itself, in the probe() routine.
>
> There is actually a generic function provided by the MMC framework doing
> this job, also it parses more generic properties like broken-cd and
> advanced transfer modes.
>
> Drop our own code and call mmc_of_parse() instead, to get all new
> features for free.
>
> Signed-off-by: Andre Przywara <andre.przyw...@arm.com>
Reviewed-by: Jaehoon Chung <jh80.ch...@samsung.com>
Best Regards,
Jaehoon Chung
> ---
> drivers/mmc/sunxi_mmc.c | 32 +++++++++++++++++---------------
> 1 file changed, 17 insertions(+), 15 deletions(-)
>
> diff --git a/drivers/mmc/sunxi_mmc.c b/drivers/mmc/sunxi_mmc.c
> index 115b519546e..178b8cf106d 100644
> --- a/drivers/mmc/sunxi_mmc.c
> +++ b/drivers/mmc/sunxi_mmc.c
> @@ -37,7 +37,6 @@ struct sunxi_mmc_priv {
> uint32_t *mclkreg;
> unsigned fatal_err;
> struct gpio_desc cd_gpio; /* Change Detect GPIO */
> - int cd_inverted; /* Inverted Card Detect */
> struct sunxi_mmc *reg;
> struct mmc_config cfg;
> };
> @@ -612,12 +611,21 @@ static int sunxi_mmc_send_cmd(struct udevice *dev,
> struct mmc_cmd *cmd,
>
> static int sunxi_mmc_getcd(struct udevice *dev)
> {
> + struct mmc *mmc = mmc_get_mmc_dev(dev);
> struct sunxi_mmc_priv *priv = dev_get_priv(dev);
>
> + /* If polling, assume that the card is always present. */
> + if ((mmc->cfg->host_caps & MMC_CAP_NONREMOVABLE) ||
> + (mmc->cfg->host_caps & MMC_CAP_NEEDS_POLL))
> + return 1;
> +
> if (dm_gpio_is_valid(&priv->cd_gpio)) {
> int cd_state = dm_gpio_get_value(&priv->cd_gpio);
>
> - return cd_state ^ priv->cd_inverted;
> + if (mmc->cfg->host_caps & MMC_CAP_CD_ACTIVE_HIGH)
> + return !cd_state;
> + else
> + return cd_state;
> }
> return 1;
> }
> @@ -649,23 +657,21 @@ static int sunxi_mmc_probe(struct udevice *dev)
> struct mmc_config *cfg = &plat->cfg;
> struct ofnode_phandle_args args;
> u32 *ccu_reg;
> - int bus_width, ret;
> + int ret;
>
> cfg->name = dev->name;
> - bus_width = dev_read_u32_default(dev, "bus-width", 1);
>
> cfg->voltages = MMC_VDD_32_33 | MMC_VDD_33_34;
> - cfg->host_caps = 0;
> - if (bus_width == 8)
> - cfg->host_caps |= MMC_MODE_8BIT;
> - if (bus_width >= 4)
> - cfg->host_caps |= MMC_MODE_4BIT;
> - cfg->host_caps |= MMC_MODE_HS_52MHz | MMC_MODE_HS;
> + cfg->host_caps = MMC_MODE_HS_52MHz | MMC_MODE_HS;
> cfg->b_max = CONFIG_SYS_MMC_MAX_BLK_COUNT;
>
> cfg->f_min = 400000;
> cfg->f_max = 52000000;
>
> + ret = mmc_of_parse(dev, cfg);
> + if (ret)
> + return ret;
> +
> priv->reg = dev_read_addr_ptr(dev);
>
> /* We don't have a sunxi clock driver so find the clock address here */
> @@ -691,17 +697,13 @@ static int sunxi_mmc_probe(struct udevice *dev)
> return ret;
>
> /* This GPIO is optional */
> - if (!dev_read_bool(dev, "non-removable") &&
> - !gpio_request_by_name(dev, "cd-gpios", 0, &priv->cd_gpio,
> + if (!gpio_request_by_name(dev, "cd-gpios", 0, &priv->cd_gpio,
> GPIOD_IS_IN)) {
> int cd_pin = gpio_get_number(&priv->cd_gpio);
>
> sunxi_gpio_set_pull(cd_pin, SUNXI_GPIO_PULL_UP);
> }
>
> - /* Check if card detect is inverted */
> - priv->cd_inverted = dev_read_bool(dev, "cd-inverted");
> -
> upriv->mmc = &plat->mmc;
>
> /* Reset controller */
>
