On Tue, Jun 29, 2021 at 8:55 PM Vladimir Oltean <vladimir.olt...@nxp.com> wrote:
>
> The enetc-2 port is used as DSA master (connected back-to-back to
> mscc_felix_port4). Since the convention is to not enable ports in the
> common SoC dtsi unless they are used on the board, then enable enetc-2
> only when mscc_felix_port4 itself is enabled.
>
> All existing device trees appear to adhere to this rule, so disable
> enetc-2 in the SoC dtsi.
>
> Signed-off-by: Vladimir Oltean <vladimir.olt...@nxp.com>
> ---
> v2->v3: none
> v1->v2: none
>
> arch/arm/dts/fsl-ls1028a.dtsi | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/arch/arm/dts/fsl-ls1028a.dtsi b/arch/arm/dts/fsl-ls1028a.dtsi
> index 21f4ef78a059..50f9b527cde1 100644
> --- a/arch/arm/dts/fsl-ls1028a.dtsi
> +++ b/arch/arm/dts/fsl-ls1028a.dtsi
> @@ -142,7 +142,7 @@
> };
> enetc2: pci@0,2 {
> reg = <0x000200 0 0 0 0>;
> - status = "okay";
> + status = "disabled";
> phy-mode = "internal";
>
> fixed-link {
> --
> 2.25.1
>
Applied to u-boot-net/master, Thanks !
Ramon
