On 01.07.21 06:26, Tony Dinh wrote:
In DM Ethernet, the old "egiga0" name is no longer valid, so replace it
with Ethernet PHY name from device tree.
Signed-off-by: Tony Dinh <mibo...@gmail.com>
---
board/zyxel/nsa310s/nsa310s.c | 15 +++++++--------
1 file changed, 7 insertions(+), 8 deletions(-)
diff --git a/board/zyxel/nsa310s/nsa310s.c b/board/zyxel/nsa310s/nsa310s.c
index cd4a7723b1..29aded1910 100644
--- a/board/zyxel/nsa310s/nsa310s.c
+++ b/board/zyxel/nsa310s/nsa310s.c
@@ -1,5 +1,6 @@
// SPDX-License-Identifier: GPL-2.0+
/*
+ * Copyright (C) 2021 Tony Dinh <mibo...@gmail.com>
AFAIU, just changing a few lines, as this patch does, does not justify
to add a copyright notice to this file.
* Copyright (C) 2015
* Gerald Kerma <drea...@doukki.net>
* Tony Dinh <mibo...@gmail.com>
@@ -81,22 +82,18 @@ int board_init(void)
return 0;
}
+#define PHY_ADR 1
You should be able to read this PHY address from the device-tree now.
No need to define this here again.
Thanks,
Stefan
+
#ifdef CONFIG_RESET_PHY_R
void reset_phy(void)
{
u16 reg;
- u16 phyaddr;
- char *name = "egiga0";
+ u16 phyaddr = PHY_ADR;
+ char *name = "ethernet-controller@72000";
if (miiphy_set_current_dev(name))
return;
- /* read PHY dev address */
- if (miiphy_read(name, 0xee, 0xee, (u16 *) &phyaddr)) {
- printf("could not read PHY dev address\n");
- return;
- }
-
/* set RGMII delay */
miiphy_write(name, phyaddr, MV88E1318_PGADR_REG, MV88E1318_MAC_CTRL_PG);
miiphy_read(name, phyaddr, MV88E1318_MAC_CTRL_REG, ®);
@@ -131,5 +128,7 @@ void reset_phy(void)
/* downshift */
miiphy_write(name, phyaddr, 0x10, 0x3860);
miiphy_write(name, phyaddr, 0x0, 0x9140);
+
+ printf("MV88E1318 PHY initialized on %s\n", name);
}
#endif /* CONFIG_RESET_PHY_R */
Viele Grüße,
Stefan
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-51 Fax: (+49)-8142-66989-80 Email: s...@denx.de