On 7/6/21 6:11 PM, Tim Harvey wrote:
On Sun, Jul 4, 2021 at 12:25 PM Marek Vasut <ma...@denx.de> wrote:
On 7/4/21 5:35 PM, Fabio Estevam wrote:
Hi Marek,
Hi,
On Sat, Jul 3, 2021 at 10:04 PM Marek Vasut <ma...@denx.de> wrote:
Retrieving the USB base addresses from DT would be preferred, yes, but
the current code does not do that.
I implemented exactly that in mx6_parse_dt_addrs() , see:
4dcfa3bcbcb ("usb: ehci-mx6: Parse USB PHY and MISC offsets from DT")
We are talking about USB_BASE_ADDR, right?
All of the addresses used by the driver, I am trying hard to get rid of
all that hard-coding in the driver. They should be parsed out of DT.
Marek,
I agree with trying to get rid of all the hard-coding but not all of
us are using SPL_DM_USB. I'm not sure how to best tell who is not
using DM in the SPL.
You should be able to use PLATDATA in SPL.
The current situation in the driver is total chaos, that must be fixed.
So, I would say in SPL -> PLATDATA , U-Boot -> DM/DT .
I know I ran into issues as I'm supporting a
family of boards with the same U-Boot and could not find a way to
switch dt's early in the SPL after I've detected via EEPROM what board
I have.
Right, the platdata should help here. Then you don't need DT.
