On 05.09.21 23:48, Tony Dinh wrote:
While a board could have multiple SATA ports, some of the ports might
not have a disk attached to them. So while probing for disks,
sata_mv_probe() should continue probing all ports, and skip one with
no disk attached.
Tests with:
- Seagate Goflex Net (Marvell Kirkwood 88F6281) out-of-tree u-boot.
- Zyxel NSA325 (Marvell Kirkwood 88F6282 out-of-tree u-boot.
Observation:
If a board has 2 or more SATA ports, and there is only one disk
attached to one of the ports, sata_mv_probe() does not return
a successful probe status. And if only one disk is attached to the
2nd port (i.e. port 1), it is not probed at all.
Patch Description:
Let sata_mv_probe() continues probing all ports, even if there
is error in probing a given port, and then return a successful
status if there is at least one port was probed successfully.
Signed-off-by: Tony Dinh <mibo...@gmail.com>
Reviewed-by: Stefan Roese <s...@denx.de>
Thanks,
Stefan
---
drivers/ata/sata_mv.c | 14 ++++++++++----
1 file changed, 10 insertions(+), 4 deletions(-)
diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c
index dadb2c7c2e..003222d47b 100644
--- a/drivers/ata/sata_mv.c
+++ b/drivers/ata/sata_mv.c
@@ -1068,6 +1068,7 @@ static int sata_mv_probe(struct udevice *dev)
int nr_ports;
int ret;
int i;
+ int status = -ENODEV; /* If the probe fails to detected any SATA port */
/* Get number of ports of this SATA controller */
nr_ports = min(fdtdec_get_int(blob, node, "nr-ports", -1),
@@ -1078,7 +1079,7 @@ static int sata_mv_probe(struct udevice *dev)
IF_TYPE_SATA, -1, 512, 0, &blk);
if (ret) {
debug("Can't create device\n");
- return ret;
+ continue;
}
priv = dev_get_plat(blk);
@@ -1088,18 +1089,23 @@ static int sata_mv_probe(struct udevice *dev)
ret = sata_mv_init_sata(blk, i);
if (ret) {
debug("%s: Failed to init bus\n", __func__);
- return ret;
+ continue;
}
/* Scan SATA port */
ret = sata_mv_scan_sata(blk, i);
if (ret) {
debug("%s: Failed to scan bus\n", __func__);
- return ret;
+ continue;
}
+
+ /* If we got here, the current SATA port was probed
+ * successfully, so set the probe status to successful.
+ */
+ status = 0;
}
- return 0;
+ return status;
}
static int sata_mv_scan(struct udevice *dev)
Viele Grüße,
Stefan
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-51 Fax: (+49)-8142-66989-80 Email: s...@denx.de
