[PATCH] boards: siemens: iot2050: Ignore network errors during bootstage tracking

[Jan Kiszka]

From: Jan Kiszka <jan.kis...@siemens.com>

We need to filter out NET_ETH_START errors because we have to enable
networking in order to propagate the MAC addresses to the DT while there
is no network driver for the prueth in U-Boot yet.

Signed-off-by: Jan Kiszka <jan.kis...@siemens.com>
---
 board/siemens/iot2050/board.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/board/siemens/iot2050/board.c b/board/siemens/iot2050/board.c
index 16ae2ffc17..b965ae9fa4 100644
--- a/board/siemens/iot2050/board.c
+++ b/board/siemens/iot2050/board.c
@@ -259,7 +259,8 @@ void show_boot_progress(int progress)
        struct udevice *dev;
        int ret;
 
-       if (progress < 0 || progress == BOOTSTAGE_ID_ENTER_CLI_LOOP) {
+       if ((progress < 0 && progress != -BOOTSTAGE_ID_NET_ETH_START) ||
+           progress == BOOTSTAGE_ID_ENTER_CLI_LOOP) {
                ret = led_get_by_label("status-led-green", &dev);
                if (ret == 0)
                        led_set_state(dev, LEDST_OFF);
-- 
2.31.1