As the document said, I tried added "#define DEBUG" in each file but it doesn't work. If I add "#define debug printf" then, of course debug() is printed.
-----Original Message----- From: U-Boot <u-boot-boun...@lists.denx.de> On Behalf Of Chan Kim Sent: Wednesday, December 22, 2021 3:13 PM To: U-Boot Mailing List <u-boot@lists.denx.de> Subject: printf works but how can I make debug() printed to serial port console? Hello all, I'm trying to boot from RAM using SPL only. (Another scp processor loads the FIT image to the SDRAM before starting u-boot-spl is started) Since the debugger doesn't work yet, I have to rely on prints to debug. The printf works fine (I once asked about initializing serial port here, and later found serial_init is done in board_init_f ). I tried to make debug(xxx) printed to serial port but couldn't figure out how to do it. I tried 1. Adding #define DEBUG to the relevant source file 2. Giving DEBUG=1 in the make command (or CFLAGS=-DDEBUG) But it doesn't work (of course I can change debug to printf to see it). How can I make debug( ) macro output to the serial port? Thank you! Chan Kim
