Dear Sean, On 11/24/21 5:03 AM, Sean Anderson wrote: > This series ports some of the patches from fsl_esdhc to fsl_esdhc_imx. > Because these drivers share a common lineage, many of these patches > apply with minor changes. For each one, I have noted the originating > commit in the style of linux stable backports. Where I have had to > modify patches, I have noted the changes I have made before my SoB. > > In fa33d20749 ("mmc: split fsl_esdhc driver for i.MX"), Yangbo says > >> For the two series processors, the eSDHCs are becoming more and more >> different > > However, these drivers are still extremely similar; the differences > between them are not major. NXP has not done a good job of porting > patches which apply to both drivers. This causes the fsl_esdhc_imx > driver to rot, as the fsl_esdhc gets more general fixes. For this > reason, I think that the fsl_esdhc_imx driver should be removed unless > NXP can commit to creating series like this which port patches which > apply to both drivers.
Sorry for too late. I had been tried to applied this series from patchwork, but i can't see [PATCH v3 01/12]. Best Regards, Jaehoon Chung > > Changes in v3: > - Drop Kconfig BLK dependency > - Fix build error caused by unconverted OF_PLATDATA code > - Replace more #ifdefs by if > > Changes in v2: > - Use a switch statement instead of ifs for max_bus_width > - Only default to 8 bit width when max_bus_width is not set > > Sean Anderson (12): > mmc: fsl_esdhc_imx: make BLK as hard requirement of DM_MMC > mmc: fsl_esdhc_imx: remove redundant DM_MMC checking > mmc: fsl_esdhc_imx: fix voltage validation > mmc: fsl_esdhc_imx: clean up bus width configuration code > mmc: fsl_esdhc_imx: drop redundant code for non-removable feature > mmc: fsl_esdhc_imx: fix mmc->clock with actual clock > mmc: fsl_esdhc_imx: simplify 64bit check for SDMA transfers > mmc: fsl_esdhc_imx: use dma-mapping API > mmc: fsl_esdhc_imx: simplify esdhc_setup_data() > mmc: fsl_esdhc_imx: replace most #ifdefs by IS_ENABLED() > mmc: fsl_esdhc_imx: Replace more #ifdefs by if > mmc: fsl_esdhc_imx: set sysctl register for clock initialization > > drivers/mmc/fsl_esdhc_imx.c | 643 ++++++++++++++---------------------- > include/fsl_esdhc_imx.h | 14 +- > 2 files changed, 263 insertions(+), 394 deletions(-) >