On 2/15/22 11:23, Pali Rohár wrote:
If a PIO request is executed while link-down, the whole controller gets
stuck in a non-functional state, and even after link comes up again, PIO
requests won't work anymore, and a reset of the whole PCIe controller is
needed. Therefore we need to prevent sending PIO requests while the link
is down.

Signed-off-by: Pali Rohár <p...@kernel.org>

Reviewed-by: Stefan Roese <s...@denx.de>

Thanks,
Stefan

---
  drivers/pci/pci-aardvark.c | 38 +++++++++++++++++++++-----------------
  1 file changed, 21 insertions(+), 17 deletions(-)

diff --git a/drivers/pci/pci-aardvark.c b/drivers/pci/pci-aardvark.c
index 1eb257ea8b4a..ccaeecaca8e3 100644
--- a/drivers/pci/pci-aardvark.c
+++ b/drivers/pci/pci-aardvark.c
@@ -177,6 +177,23 @@ static inline uint advk_readl(struct pcie_advk *pcie, uint 
reg)
        return readl(pcie->base + reg);
  }
+/**
+ * pcie_advk_link_up() - Check if PCIe link is up or not
+ *
+ * @pcie: The PCI device to access
+ *
+ * Return true on link up.
+ * Return false on link down.
+ */
+static bool pcie_advk_link_up(struct pcie_advk *pcie)
+{
+       u32 val, ltssm_state;
+
+       val = advk_readl(pcie, ADVK_LMI_PHY_CFG0);
+       ltssm_state = (val & ADVK_LMI_PHY_CFG0_LTSSM_MASK) >> 
ADVK_LMI_PHY_CFG0_LTSSM_SHIFT;
+       return ltssm_state >= ADVK_LMI_PHY_CFG0_LTSSM_L0 && ltssm_state < 
ADVK_LMI_PHY_CFG0_LTSSM_DISABLED;
+}
+
  /**
   * pcie_advk_addr_valid() - Check for valid bus address
   *
@@ -195,6 +212,10 @@ static bool pcie_advk_addr_valid(struct pcie_advk *pcie,
        if (busno == 0 && (dev != 0 || func != 0))
                return false;
+ /* Access to other buses is possible when link is up */
+       if (busno != 0 && !pcie_advk_link_up(pcie))
+               return false;
+
        /*
         * In PCI-E only a single device (0) can exist on the secondary bus.
         * Beyond the secondary bus, there might be a Switch and anything is
@@ -618,23 +639,6 @@ retry:
        return ret;
  }
-/**
- * pcie_advk_link_up() - Check if PCIe link is up or not
- *
- * @pcie: The PCI device to access
- *
- * Return 1 (true) on link up.
- * Return 0 (false) on link down.
- */
-static int pcie_advk_link_up(struct pcie_advk *pcie)
-{
-       u32 val, ltssm_state;
-
-       val = advk_readl(pcie, ADVK_LMI_PHY_CFG0);
-       ltssm_state = (val & ADVK_LMI_PHY_CFG0_LTSSM_MASK) >> 
ADVK_LMI_PHY_CFG0_LTSSM_SHIFT;
-       return ltssm_state >= ADVK_LMI_PHY_CFG0_LTSSM_L0 && ltssm_state < 
ADVK_LMI_PHY_CFG0_LTSSM_DISABLED;
-}
-
  /**
   * pcie_advk_wait_for_link() - Wait for link training to be accomplished
   *

Viele Grüße,
Stefan Roese

--
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-51 Fax: (+49)-8142-66989-80 Email: s...@denx.de

Reply via email to