On 2/22/22 17:00, Michael Walle wrote:
Am 2022-02-22 16:19, schrieb Heiko Thiery:
With the correct settings described in the device-tree the PHY settings
in the board init are no longer required. The values are taken from the
linux device tree.
Suggested-by: Michael Walle <mich...@walle.cc>
Signed-off-by: Heiko Thiery <heiko.thi...@gmail.com>
---
v2:
- remove phy-reset-gpios node (thanks to Michael)
When using DM_ETH_PHY the reset-gpios from the phy is used
arch/arm/dts/imx8mn-evk.dtsi | 10 +++++++++-
board/freescale/imx8mn_evk/imx8mn_evk.c | 16 ----------------
2 files changed, 9 insertions(+), 17 deletions(-)
It seems someone was faster with this patch after all, thanks.
diff --git a/arch/arm/dts/imx8mn-evk.dtsi b/arch/arm/dts/imx8mn-evk.dtsi
index 416fadb22b..fd253f0042 100644
--- a/arch/arm/dts/imx8mn-evk.dtsi
+++ b/arch/arm/dts/imx8mn-evk.dtsi
@@ -53,7 +53,6 @@
pinctrl-0 = <&pinctrl_fec1>;
phy-mode = "rgmii-id";
phy-handle = <ðphy0>;
- phy-reset-gpios = <&gpio4 22 GPIO_ACTIVE_LOW>;
This ...
I'm afraid the phy reset in the phy node won't really end up toggling
the PHY reset GPIO, would it ?
[...]