From: Peng Fan <peng....@nxp.com>
pinctrl_wdog already marked u-boot,dm-spl, so clean up board code.
The set_wdog_reset() function is not necessary as this is handled by
the imx_watchdog.c driver due to the 'fsl,ext-reset-output' property
being set.
Signed-off-by: Peng Fan <peng....@nxp.com>
Tested-by: Ariel D'Alessandro <ariel.dalessan...@collabora.com>
---
board/bsh/imx8mn_smm_s2/spl.c | 11 -----------
1 file changed, 11 deletions(-)
diff --git a/board/bsh/imx8mn_smm_s2/spl.c b/board/bsh/imx8mn_smm_s2/spl.c
index 0f61acc6302..4ccee7c31a8 100644
--- a/board/bsh/imx8mn_smm_s2/spl.c
+++ b/board/bsh/imx8mn_smm_s2/spl.c
@@ -40,19 +40,8 @@ void spl_board_init(void)
puts("Failed to find clock node. Check device tree\n");
}
-#define WDOG_PAD_CTRL (PAD_CTL_DSE6 | PAD_CTL_ODE | PAD_CTL_PUE | PAD_CTL_PE)
-
-static const iomux_v3_cfg_t wdog_pads[] = {
- IMX8MN_PAD_GPIO1_IO02__WDOG1_WDOG_B | MUX_PAD_CTRL(WDOG_PAD_CTRL),
-};
-
int board_early_init_f(void)
{
- struct wdog_regs *wdog = (struct wdog_regs *)WDOG1_BASE_ADDR;
-
- imx_iomux_v3_setup_multiple_pads(wdog_pads, ARRAY_SIZE(wdog_pads));
- set_wdog_reset(wdog);
-
init_uart_clk(3);
if (IS_ENABLED(CONFIG_NAND_MXS)) {
--
2.36.0
