On 15.06.22 20:00, Tom Rini wrote:
Hey all,
As I migrate assorted CONFIG options over to Kconfig, a common problem I
run in to is that between m68k, PowerPC and ARM (both Layerscape and
sometimes i.MX) there are options that fit under more than one
architecture but also don't have a good place to go. For example, I
just ran in to CONFIG_SYS_FSL_NUM_CC_PLLS which started as PowerPC
specific, but is used still in Layerscape and more of a SoC detail (but
wouldn't make sense in drivers/soc/Kconfig).
That's right, there is IP in common that can be factorized.
I was thinking that
perhaps arch/Kconfig.nxp would be a good starting place to put these
options, but I'm quite open to other suggestions.
+1
It looks to me a good idea ;-)
Regards,
Stefano
--
=====================================================================
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, 82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
