Hi Stefano,
Thank you for applying this patchset.
This patch had a functional flaw that I was intending to address in v3.
Instead I have now followed up with a separate patch:
[PATCH] mx6cuboxi: fix board detection while patching device-tree phy nodes
Please make sure this one is added too.
sincerely
Josua Mayer
Am 15.06.22 um 14:11 schrieb sba...@denx.de:
SoM revision 1.9 has replaced the ar8035 phy address 0 with an adin1300
at address 1. Because early SoMs had a hardware flaw, the ar8035 can
also appear at address 4 - making it a total of 3 phy nodes in the DTB.
To avoid confusing Linux with probe errors, fixup the dtb to only enable
the phy node that is detected at runtime.
Signed-off-by: Josua Mayer <jo...@solid-run.com>
Applied to u-boot-imx, master, thanks !
Best regards,
Stefano Babic
