> -----Original Message----- > From: Marek Vasut [mailto:ma...@denx.de] > Sent: Thursday, June 30, 2022 5:20 PM > > On 6/30/22 16:19, Johann Neuhauser wrote: > > PA13 and PA14 are used for USB power control and can't be used > > to enforce fastboot or stm32prog mode by pressing a button. > > > > Defining CONFIG_FASTBOOT/CONFIG_CMD_STM32PROG without this patch applied > > results in fastboot/stm32prog always starting, because PA13/PA14 are always > > low during boot. So drop the wrong trigger gpios definitions. > > > > Signed-off-by: Johann Neuhauser <jneuhau...@dh-electronics.com> > > Those GPIOs also likely make no sense on DHCOM , right ?
They would only make sense on the DHCOM PDK2, since this is the only mainline baseboard with user buttons available in U-Boot. > > Reviewed-by: Marek Vasut <ma...@denx.de>