El Fri, Jul 15, 2022 at 05:09:49PM +0200, Quentin Schulz deia:
> From: Quentin Schulz <quentin.sch...@theobroma-systems.com>
>
> The check to perform is on CONFIG_SPL_GPIO and not SPL_GPIO.
> Because this was never compiled in, it missed an include of cru.h that
> was not detected before. Let's include it too.
>
> Also switch to IS_ENABLED ifdef and in-code check.
>
> Fixes: 07586ee4322a ("rockchip: rk3399: Support common spl_board_init")
> Cc: Quentin Schulz <foss+ub...@0leil.net>
> Signed-off-by: Quentin Schulz <quentin.sch...@theobroma-systems.com>
> ---
>
I've tested this on a Rock-Pi-4B, but with the patch below on top
and I haven't seen any regression. So, with this small correction:
Tested-by: Xavier Drudis Ferran <xdru...@tinet.cat>
> v2:
> - use IS_ENABLED checks,
>
> arch/arm/mach-rockchip/rk3399/rk3399.c | 45 ++++++++++++++------------
> 1 file changed, 24 insertions(+), 21 deletions(-)
>
> diff --git a/arch/arm/mach-rockchip/rk3399/rk3399.c
> b/arch/arm/mach-rockchip/rk3399/rk3399.c
> index 920da22307..db8a6cb83a 100644
> --- a/arch/arm/mach-rockchip/rk3399/rk3399.c
> +++ b/arch/arm/mach-rockchip/rk3399/rk3399.c
> @@ -221,7 +221,9 @@ void spl_perform_fixups(struct spl_image_info *spl_image)
> "u-boot,spl-boot-device", boot_ofpath);
> }
>
> -#if defined(SPL_GPIO)
> +#if IS_ENABLED(CONFIG_SPL_GPIO)
> +
> +#include <asm/arch-rockchip/cru.h>
> static void rk3399_force_power_on_reset(void)
> {
> ofnode node;
> @@ -253,27 +255,28 @@ void spl_board_init(void)
> {
> led_setup();
>
> -#if defined(SPL_GPIO)
> - struct rockchip_cru *cru = rockchip_get_cru();
> + if (IS_ENABLED(CONFIG_SPL_GPIO)) {
> + struct rockchip_cru *cru = rockchip_get_cru();
>
> - /*
> - * The RK3399 resets only 'almost all logic' (see also in the TRM
> - * "3.9.4 Global software reset"), when issuing a software reset.
> - * This may cause issues during boot-up for some configurations of
> - * the application software stack.
> - *
> - * To work around this, we test whether the last reset reason was
> - * a power-on reset and (if not) issue an overtemp-reset to reset
> - * the entire module.
> - *
> - * While this was previously fixed by modifying the various places
> - * that could generate a software reset (e.g. U-Boot's sysreset
> - * driver, the ATF or Linux), we now have it here to ensure that
> - * we no longer have to track this through the various components.
> - */
> - if (cru->glb_rst_st != 0)
> - rk3399_force_power_on_reset();
> -#endif
> + /*
> + * The RK3399 resets only 'almost all logic' (see also in the
> + * TRM "3.9.4 Global software reset"), when issuing a software
> + * reset. This may cause issues during boot-up for some
> + * configurations of the application software stack.
> + *
> + * To work around this, we test whether the last reset reason
> + * was a power-on reset and (if not) issue an overtemp-reset to
> + * reset the entire module.
> + *
> + * While this was previously fixed by modifying the various
> + * places that could generate a software reset (e.g. U-Boot's
> + * sysreset driver, the ATF or Linux), we now have it here to
> + * ensure that we no longer have to track this through the
> + * various components.
> + */
> + if (cru->glb_rst_st != 0)
> + rk3399_force_power_on_reset();
> + }
>
> if (IS_ENABLED(CONFIG_SPL_DM_REGULATOR)) {
> /*
> --
> 2.36.1
>
The small correction (now that I think of it, the include might as well go at
the top of file):
---
arch/arm/mach-rockchip/rk3399/rk3399.c | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)
diff --git a/arch/arm/mach-rockchip/rk3399/rk3399.c
b/arch/arm/mach-rockchip/rk3399/rk3399.c
index fced5c7e21..10b911f998 100644
--- a/arch/arm/mach-rockchip/rk3399/rk3399.c
+++ b/arch/arm/mach-rockchip/rk3399/rk3399.c
@@ -221,9 +221,9 @@ void spl_perform_fixups(struct spl_image_info *spl_image)
"u-boot,spl-boot-device", boot_ofpath);
}
+#include <asm/arch-rockchip/cru.h>
#if IS_ENABLED(CONFIG_SPL_GPIO)
-#include <asm/arch-rockchip/cru.h>
static void rk3399_force_power_on_reset(void)
{
ofnode node;
@@ -245,6 +245,10 @@ static void rk3399_force_power_on_reset(void)
dm_gpio_set_value(&sysreset_gpio, 1);
}
+#else
+static inline void rk3399_force_power_on_reset(void)
+{
+}
#endif
void __weak led_setup(void)
--
2.20.1
