From: Samuel Mendoza-Jonas <s...@mendozajonas.com>
Adds an "ncsi" command to manually start NC-SI configuration.
Signed-off-by: Samuel Mendoza-Jonas <s...@mendozajonas.com>
Signed-off-by: Joel Stanley <j...@jms.id.au>
---
v4: New patch, split from patch 1
cmd/net.c | 22 ++++++++++++++++++++++
net/net.c | 1 +
cmd/Kconfig | 8 ++++++++
3 files changed, 31 insertions(+)
diff --git a/cmd/net.c b/cmd/net.c
index 3619c843d838..2863fe768118 100644
--- a/cmd/net.c
+++ b/cmd/net.c
@@ -16,6 +16,7 @@
#include <net.h>
#include <net/udp.h>
#include <net/sntp.h>
+#include <net/ncsi.h>
static int netboot_common(enum proto_t, struct cmd_tbl *, int, char * const
[]);
@@ -524,3 +525,24 @@ U_BOOT_CMD(
"list - list available devices\n"
);
#endif // CONFIG_DM_ETH
+
+#if defined(CONFIG_CMD_NCSI)
+static int do_ncsi(struct cmd_tbl *cmdtp, int flag, int argc, char * const
argv[])
+{
+ if (!phy_interface_is_ncsi() || !ncsi_active()) {
+ printf("Device not configured for NC-SI\n");
+ return CMD_RET_FAILURE;
+ }
+
+ if (net_loop(NCSI) < 0)
+ return CMD_RET_FAILURE;
+
+ return CMD_RET_SUCCESS;
+}
+
+U_BOOT_CMD(
+ ncsi, 1, 1, do_ncsi,
+ "Configure attached NIC via NC-SI",
+ ""
+);
+#endif /* CONFIG_CMD_NCSI */
diff --git a/net/net.c b/net/net.c
index f0faf33d0d77..a4e645ac4425 100644
--- a/net/net.c
+++ b/net/net.c
@@ -434,6 +434,7 @@ int net_loop(enum proto_t protocol)
} else {
eth_init_state_only();
}
+
restart:
#ifdef CONFIG_USB_KEYBOARD
net_busy_flag = 0;
diff --git a/cmd/Kconfig b/cmd/Kconfig
index 3625ff2a50b3..3a5d1bba78a8 100644
--- a/cmd/Kconfig
+++ b/cmd/Kconfig
@@ -1813,6 +1813,14 @@ config CMD_LINK_LOCAL
help
Acquire a network IP address using the link-local protocol
+config CMD_NCSI
+ bool "ncsi"
+ depends on PHY_NCSI
+ help
+ Manually configure the attached NIC via NC-SI.
+ Normally this happens automatically before other network
+ operations.
+
endif
config CMD_ETHSW
--
2.35.1
