Hi Stefan, Sorry, that message was prematurely sent (fat finger). Please see the continuation below.
On Sat, Sep 3, 2022 at 4:43 PM Tony Dinh <mibo...@gmail.com> wrote: > > Hi Stefan, > > On Sat, Sep 3, 2022 at 3:44 AM Stefan Roese <s...@denx.de> wrote: > > > > Hi Tony, > > > > On 03.09.22 11:44, Tony Dinh wrote: > > > Hi Stefan, > > > > > > On Thu, Sep 1, 2022 at 11:25 PM Stefan Roese <s...@denx.de> wrote: > > >> > > >> Add timer_get_boot_us() to support boards, that have CONFIG_BOOTSTAGE > > >> enabled, like pogo_v4. > > >> > > >> Signed-off-by: Stefan Roese <s...@denx.de> > > >> --- > > >> v2: > > >> - Change timer_get_boot_us() to use the timer_early functions > > >> - Remove #if CONFIG_IS_ENABLED(BOOTSTAGE) > > >> > > >> Simon, I'm currently looking into this timer_get_boot_us() to using > > >> timer_early_get_count() etc consolidation. > > > > > > Indeed, as you've mentioned above, I think timer_early_get_count() and > > > timer_early_get_rate() do need to take into consideration what the > > > input_clock_type is for Kirkwood boards with CONFIG_BOOTSTAGE such as > > > the Pogo V4. > > > > > > I'm seeing on the Pogo V4 test, the timer command reports time about 6 > > > times slower than it should. It does seem to jive with the fact that > > > the Pogo V4 CONFIG_SYS_TCLK is 166Mhz, versus MVEBU 25MHz clock rate. > > > > Ah, I've missing updating the early functions to also differentiate > > between fixed clocks and TCLK timer. > > > > Please give the attached patch a try - should be applied on top of this > > latest patchset. > That looks promising, but I think we are still missing something. After applying the attached patch, I ran the test again and it behaved the same way (clock rate 6 times slower). So I did another test. --- Test 1 Pogo_V4> timer start; sleep 60; timer get; sleep 30; timer get 60.000 90.000 So apparently the sleep cmd has reset the correct clock rate. --- Test 2 Pogo_V4> timer start; sleep 30; timer get; sleep 30; timer get 30.000 60.000 And then wait for 30 seconds, do another "timer get" (I expected to see about 90 to 95 seconds). Pogo_V4> timer get 66.237 The different call tree with the timer vs the sleep command made a difference. But I could not see where. --- Test 3 Then I recalled about CONFIG_TIMER_EARLY. It is not selected by default in Kconfig currently. So I enabled that to see the behavior. But running this build hangs right off the bat. No u-boot version banner is printed out. Thanks, Tony > > > > > Thanks, > > Stefan