[PATCH 1/3] mmc: stm32_sdmmc2: add dual data rate support

[Yann Gautier]

To support dual data rate with STM32 sdmmc2 driver, the dedicated bit
(DDR - BIT(18)) needs to be set in the CLKRC register. Clock bypass
(no divider) is not allowed in this case. This is required for the
eMMC DDR modes.

Signed-off-by: Yann Gautier <yann.gaut...@foss.st.com>
---

 drivers/mmc/stm32_sdmmc2.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/stm32_sdmmc2.c b/drivers/mmc/stm32_sdmmc2.c
index bfce8a2e4a..3cfa5a66f1 100644
--- a/drivers/mmc/stm32_sdmmc2.c
+++ b/drivers/mmc/stm32_sdmmc2.c
@@ -598,13 +598,16 @@ static int stm32_sdmmc2_set_ios(struct udevice *dev)
         * clk_div > 0 and NEGEDGE = 1 => command and data generated on
         * SDMMCCLK falling edge
         */
-       if (desired && ((sys_clock > desired) ||
+       if (desired && (sys_clock > desired || mmc->ddr_mode ||
                        IS_RISING_EDGE(plat->clk_reg_msk))) {
                clk = DIV_ROUND_UP(sys_clock, 2 * desired);
                if (clk > SDMMC_CLKCR_CLKDIV_MAX)
                        clk = SDMMC_CLKCR_CLKDIV_MAX;
        }
 
+       if (mmc->ddr_mode)
+               clk |= SDMMC_CLKCR_DDR;
+
        if (mmc->bus_width == 4)
                clk |= SDMMC_CLKCR_WIDBUS_4;
        if (mmc->bus_width == 8)
-- 
2.25.1