This patch add FEC support for Freescale MX53 processor
Signed-off-by: Jason Liu <r64...@freescale.com>
---
drivers/net/fec_mxc.c | 2 +-
drivers/net/fec_mxc.h | 4 ++--
2 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c
index 0d0f392..652ced4 100644
--- a/drivers/net/fec_mxc.c
+++ b/drivers/net/fec_mxc.c
@@ -354,7 +354,7 @@ static int fec_open(struct eth_device *edev)
*/
writel(readl(&fec->eth->ecntrl) | FEC_ECNTRL_ETHER_EN,
&fec->eth->ecntrl);
-#ifdef CONFIG_MX25
+#if defined(CONFIG_MX25) || defined(CONFIG_MX53)
udelay(100);
/*
* setup the MII gasket for RMII mode
diff --git a/drivers/net/fec_mxc.h b/drivers/net/fec_mxc.h
index 5d0d69d..1ba5161 100644
--- a/drivers/net/fec_mxc.h
+++ b/drivers/net/fec_mxc.h
@@ -147,7 +147,7 @@ struct ethernet_regs {
uint32_t res14[7]; /* MBAR_ETH + 0x2E4-2FC */
-#ifdef CONFIG_MX25
+#if defined(CONFIG_MX25) || defined(CONFIG_MX53)
uint16_t miigsk_cfgr; /* MBAR_ETH + 0x300 */
uint16_t res15[3]; /* MBAR_ETH + 0x302-306 */
uint16_t miigsk_enr; /* MBAR_ETH + 0x308 */
@@ -204,7 +204,7 @@ struct ethernet_regs {
#define FEC_ECNTRL_RESET 0x00000001 /* reset the FEC */
#define FEC_ECNTRL_ETHER_EN 0x00000002 /* enable the FEC */
-#ifdef CONFIG_MX25
+#if defined(CONFIG_MX25) || defined(CONFIG_MX53)
/* defines for MIIGSK */
/* RMII frequency control: 0=50MHz, 1=5MHz */
#define MIIGSK_CFGR_FRCONT (1 << 6)
--
1.7.0.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
