While it is possible and documented on how to re-run buildman to replace
faked required binary files after the fact, this behavior ends up being
more confusing than helpful in practice. Switch to requiring
BINMAN_ALLOW_MISSING=1 to be passed on the 'make' line to enable this
behavior.
Cc: Rasmus Villemoes <rasmus.villem...@prevas.dk>
Cc: Simon Glass <s...@chromium.org>
Signed-off-by: Tom Rini <tr...@konsulko.com>
---
Makefile | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/Makefile b/Makefile
index 45f10759a137..535e52443ebf 100644
--- a/Makefile
+++ b/Makefile
@@ -1345,8 +1345,8 @@ cmd_binman = $(srctree)/tools/binman/binman $(if
$(BINMAN_DEBUG),-D) \
$(foreach f,$(BINMAN_TOOLPATHS),--toolpath $(f)) \
--toolpath $(objtree)/tools \
$(if $(BINMAN_VERBOSE),-v$(BINMAN_VERBOSE)) \
- build -u -d u-boot.dtb -O . -m --allow-missing \
- --fake-ext-blobs \
+ build -u -d u-boot.dtb -O . -m \
+ $(if $(BINMAN_ALLOW_MISSING),--allow-missing --fake-ext-blobs) \
-I . -I $(srctree) -I $(srctree)/board/$(BOARDDIR) \
-I arch/$(ARCH)/dts -a of-list=$(CONFIG_OF_LIST) \
$(foreach f,$(BINMAN_INDIRS),-I $(f)) \
--
2.25.1
