Hi Johannes,
On 02/11/2022 09:38, SCHNEIDER Johannes wrote:
sadly that does not reproduce on imx8mm ... a long print works fine
with or without the patch :-S
Yes, it does happen on imx8mm.
You need to add the print() inside board_init().
Here is a reproducer on imx8mm evk:
diff --git a/board/freescale/imx8mm_evk/imx8mm_evk.c
b/board/freescale/imx8mm_evk/imx8mm_evk.c
index e0975fcda705..69ec723c616e 100644
--- a/board/freescale/imx8mm_evk/imx8mm_evk.c
+++ b/board/freescale/imx8mm_evk/imx8mm_evk.c
@@ -50,6 +50,7 @@ int board_init(void)
if (IS_ENABLED(CONFIG_FEC_MXC))
setup_fec();
+
printf("*******************0123456789012345678901234567890123456789\n");
return 0;
}
The result is:
U-Boot SPL 2022.10-00991-gc8d9ff634fc4-dirty (Nov 02 2022 - 11:15:14
-0300)
No pmic
SEC0: RNG instantiated
cyclic_register for watchdog@30280000 failed
WDT: Failed to start watchdog@30280000
Trying to boot from MMC1
NOTICE: BL31: v2.6(release):lf-5.15.32-2.0.0-1-g044ea08c0109
NOTICE: BL31: Built : 11:15:02, Nov 2 2022
U-Boot 2022.10-00991-gc8d9ff634fc4-dirty (Nov 02 2022 - 11:15:14 -0300)
CPU: Freescale i.MX8MMQ rev1.0 at 1200 MHz
Reset cause: POR
Model: FSL i.MX8MM EVK board
DRAM: 2 GiB
*******************0123456789012345678901234567890123n�KW�'$HL��
devices, 23 uclasses, devicetree: separate
WDT: Started watchdog@30280000 with servicing every 1000ms (60s
timeout)
MMC: FSL_SDHC: 1, FSL_SDHC: 2
Loading Environment from MMC... OK
In: serial@30890000
Out: serial@30890000
Err: serial@30890000
SEC0: RNG instantiated
Net: eth0: ethernet@30be0000
Hit any key to stop autoboot: 0
u-boot=>
As you can see the corruption is clearly seen.
The RTC line is displayed from drivers/misc/gsc.c and the Core: comes
from dm_announce. Somehow in between the FIFO does not get drained
before dm_announce gets called.
"flushing" shouldn't be an issue, since everything goes through the
same set of registers which the imx queues into its fifo...
i suspect the rootcause lies someplace else?
Reverting your change makes the issue disappear.
Regards,
Fabio Estevam
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-60 Fax: (+49)-8142-66989-80 Email:
feste...@denx.de
