On Wednesday 21 December 2022 09:15:41 Bin Meng wrote: > On Wed, Dec 21, 2022 at 4:06 AM Pali Rohár <p...@kernel.org> wrote: > > > > qemu can emulate also e500v1 core but cannot emulate CPUs from Freescale > > PowerPC QorIQ T and P series. > > > > Signed-off-by: Pali Rohár <p...@kernel.org> > > --- > > doc/board/emulation/qemu-ppce500.rst | 8 +++++--- > > 1 file changed, 5 insertions(+), 3 deletions(-) > > > > diff --git a/doc/board/emulation/qemu-ppce500.rst > > b/doc/board/emulation/qemu-ppce500.rst > > index 5de0aaf55ded..10427cc56302 100644 > > --- a/doc/board/emulation/qemu-ppce500.rst > > +++ b/doc/board/emulation/qemu-ppce500.rst > > @@ -7,7 +7,7 @@ QEMU PPC E500 > > QEMU for PPC supports a special 'ppce500' machine designed for emulation > > and > > virtualization purposes. This document describes how to run U-Boot under > > it. > > > > -The QEMU ppce500 machine models a generic PowerPC E500 virtual machine with > > +The QEMU ppce500 machine models a generic PowerPC e500 virtual machine with > > support for the VirtIO standard networking device connected to the built-in > > PCI host controller. Some common devices in the CCSBAR space are modeled, > > including MPIC, 16550A UART devices, GPIO, I2C and PCI host controller with > > @@ -39,6 +39,7 @@ embedded DTB created by QEMU reflects the new setting. > > Both qemu-system-ppc and qemu-system-ppc64 provide emulation for the > > following > > 32-bit PowerPC CPUs: > > > > +* e500v1 > > * e500v2 > > * e500mc > > > > @@ -61,8 +62,9 @@ When U-Boot boots, you will notice the following:: > > This is because we only specified a core name to QEMU and it does not have > > a > > meaningful SVR value which represents an actual SoC that integrates such > > core. > > You can specify a real world SoC device that QEMU has built-in support but > > all > > -these SoCs are e500v2 based MPC85xx series, hence you cannot test anything > > -built for P4080 (e500mc), P5020 (e5500) and T2080 (e6500). > > +these SoCs are e500v1/e500v2 based MPC85xx series, hence you cannot test > > anything > > +built for P10xx/P2010/P2020 (e500v2), P2O4x/P304x/P40xx (e500mc), > > P50xx/T10xx (e5500) > > typo: P2O4x
Where is a typo? I wrote P204x (which should mean both P2040 and P2041). > > +and T208x/T4080/T4160/T4240 (e6500). > > > > By default a VirtIO standard PCI networking device is connected as an > > ethernet > > interface at PCI address 0.1.0, but we can switch that to an e1000 NIC by:: > > -- > > Regards, > Bin