Now that DM_ETH is enabled by default and even the ldpaa_eth driver doesn't have support for the non-DM_ETH use case (see commit below), remove non-DM_ETH code from the board files. commit cde5a844fbba ("net: ldpaa_eth: Remove non-DM_ETH code")
There is no point in keeping around the creation of the MDIO bus or the hardcoded MDIO PHY addresses since we have these described in the DTS. And if there is any RCW combination which is still not supported / described by DTS we can always look in the commit history. Ioana Ciornei (5): board: freescale: lx2160a: remove hardcoded ethernet initialization board: freescale: lx2160a: remove code under !CONFIG_DM_ETH board: freescale: ls2080rdb: remove code under !CONFIG_DM_ETH board: freescale: ls2080aqds: remove code under !CONFIG_DM_ETH board: freescale: ls1088a: remove code under !CONFIG_DM_ETH board/freescale/ls1088a/eth_ls1088aqds.c | 739 +--------------- board/freescale/ls1088a/eth_ls1088ardb.c | 93 -- board/freescale/ls1088a/ls1088a.c | 2 +- board/freescale/ls2080aqds/eth.c | 981 +-------------------- board/freescale/ls2080aqds/ls2080aqds.c | 2 +- board/freescale/ls2080ardb/eth_ls2080rdb.c | 95 -- board/freescale/ls2080ardb/ls2080ardb.c | 2 +- board/freescale/lx2160a/eth_lx2160aqds.c | 825 +---------------- board/freescale/lx2160a/eth_lx2160ardb.c | 176 ---- board/freescale/lx2160a/eth_lx2162aqds.c | 844 +----------------- board/freescale/lx2160a/lx2160a.c | 6 +- 11 files changed, 17 insertions(+), 3748 deletions(-) -- 2.25.1