On Sat, 25 Feb 2023 at 22:14, Pali Rohár <p...@kernel.org> wrote: > On Saturday 25 February 2023 22:49:56 Pali Rohár wrote: > > On Saturday 25 February 2023 11:42:19 Martin Rowe wrote: > > > A388 Clearfog MMC is either SD Card or eMMC with different behaviour for > > > both. Setting MMC_BROKEN_CD allows both to correctly detect MMC. > > > > > > Signed-off-by: Martin Rowe <martin.p.r...@gmail.com> > > > > It looks like a hack but I think we do not have a better option for now. > > > > If I understand the issue correctly then card-detect pin is unconnected > > for eMMC variant and used for checking if SD card is present for SD > > variant. Unconnected pin seems to have some internal pull-up/down which > > reports not-present state for eMMC variant. eMMC does not have any > > presence signal, so card-detect pin must be ignored for eMMC. > > > > This looks like a chicken and egg problem and the only option to support > > both variants is to ignore card-detect pin and always try to initialize > > device connected to mmc controller (which may be eMMC or SD). > > Hm... maybe better way could be to edit armada-388-clearfog-u-boot.dtsi > file and add there this? /delete-property/ cd-gpios;
I just tried this and the device is not detected again; adding "non-removable" seems to be required if changing the dts. > > I do not know if there is a better option for ignoring card-detect pin > > in u-boot, so: I should point out that I did investigate runtime detection. Patching the fdt alone didn't seem to work using the hooks that were available, so I started looking into how MMC was being initialised to figure out if there was something changing the state of the device before it was returned to BootROM. I ended up in drivers/mmc/mmc.c mmc_start_init trying to figure out how we always end up with the "MMC: no card present" message in the eMMC case. I was going to write some extra logic around the mmc_getcd call, but realised there was already an ifndef with a config that seemed like this exact use-case. Given that config solved the problem it seemed like the cleanest solution. > > Acked-by: Pali Rohár <p...@kernel.org> > > > > > --- > > > configs/clearfog_defconfig | 3 +-- > > > configs/clearfog_sata_defconfig | 8 ++++---- > > > 2 files changed, 5 insertions(+), 6 deletions(-) > > > > > > diff --git a/configs/clearfog_defconfig b/configs/clearfog_defconfig > > > index 8cd35f9f1a..24e7c16ac7 100644 > > > --- a/configs/clearfog_defconfig > > > +++ b/configs/clearfog_defconfig > > > @@ -46,7 +46,6 @@ CONFIG_CMD_USB=y > > > CONFIG_CMD_TFTPPUT=y > > > CONFIG_CMD_CACHE=y > > > CONFIG_CMD_TIME=y > > > -CONFIG_CMD_MVEBU_BUBT=y > > > CONFIG_ENV_OVERWRITE=y > > > CONFIG_ENV_MIN_ENTRIES=128 > > > CONFIG_ARP_TIMEOUT=200 > > > @@ -59,7 +58,7 @@ CONFIG_DM_I2C=y > > > CONFIG_SYS_I2C_MVTWSI=y > > > CONFIG_I2C_EEPROM=y > > > CONFIG_SPL_I2C_EEPROM=y > > > -CONFIG_SUPPORT_EMMC_BOOT=y > > > +CONFIG_MMC_BROKEN_CD=y > > > CONFIG_MMC_SDHCI=y > > > CONFIG_MMC_SDHCI_SDMA=y > > > CONFIG_MMC_SDHCI_MV=y > > > diff --git a/configs/clearfog_sata_defconfig > > > b/configs/clearfog_sata_defconfig > > > index e9b36150ea..84f900bf50 100644 > > > --- a/configs/clearfog_sata_defconfig > > > +++ b/configs/clearfog_sata_defconfig > > > @@ -6,11 +6,14 @@ CONFIG_TEXT_BASE=0x00800000 > > > CONFIG_SPL_LIBCOMMON_SUPPORT=y > > > CONFIG_SPL_LIBGENERIC_SUPPORT=y > > > CONFIG_NR_DRAM_BANKS=2 > > > +CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y > > > +CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0xff0000 > > > CONFIG_TARGET_CLEARFOG=y > > > CONFIG_MVEBU_SPL_BOOT_DEVICE_SATA=y > > > CONFIG_DEFAULT_DEVICE_TREE="armada-388-clearfog" > > > CONFIG_SPL_TEXT_BASE=0x40000030 > > > CONFIG_SPL_SERIAL=y > > > +CONFIG_SPL_STACK=0x4002c000 > > > CONFIG_SPL=y > > > CONFIG_DEBUG_UART_BASE=0xf1012000 > > > CONFIG_DEBUG_UART_CLOCK=250000000 > > > @@ -18,8 +21,6 @@ CONFIG_SYS_LOAD_ADDR=0x800000 > > > CONFIG_DEBUG_UART=y > > > CONFIG_AHCI=y > > > CONFIG_DISTRO_DEFAULTS=y > > > -CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y > > > -CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0xff0000 > > > CONFIG_BOOTDELAY=3 > > > CONFIG_USE_PREBOOT=y > > > CONFIG_SYS_CONSOLE_INFO_QUIET=y > > > @@ -31,7 +32,6 @@ CONFIG_SPL_BSS_START_ADDR=0x40023000 > > > CONFIG_SPL_BSS_MAX_SIZE=0x4000 > > > CONFIG_SPL_SYS_MALLOC_SIMPLE=y > > > # CONFIG_SPL_SHARES_INIT_SP_ADDR is not set > > > -CONFIG_SPL_STACK=0x4002c000 > > > CONFIG_SPL_I2C=y > > > CONFIG_SYS_MAXARGS=32 > > > CONFIG_CMD_TLV_EEPROM=y > > > @@ -46,7 +46,6 @@ CONFIG_CMD_USB=y > > > CONFIG_CMD_TFTPPUT=y > > > CONFIG_CMD_CACHE=y > > > CONFIG_CMD_TIME=y > > > -CONFIG_CMD_MVEBU_BUBT=y > > > CONFIG_ENV_OVERWRITE=y > > > CONFIG_ENV_MIN_ENTRIES=128 > > > CONFIG_ARP_TIMEOUT=200 > > > @@ -59,6 +58,7 @@ CONFIG_DM_I2C=y > > > CONFIG_SYS_I2C_MVTWSI=y > > > CONFIG_I2C_EEPROM=y > > > CONFIG_SPL_I2C_EEPROM=y > > > +CONFIG_MMC_BROKEN_CD=y > > > CONFIG_SUPPORT_EMMC_BOOT=y > > > CONFIG_MMC_SDHCI=y > > > CONFIG_MMC_SDHCI_SDMA=y > > > -- > > > 2.39.2 > > >