Hi Bryan
On 10/04/23 20:09, Bryan Brattlof wrote:
Hi Neha!
On April 10, 2023 thus sayeth Neha Malcom Francis:
Add support for ESM (Error Signalling Module) in J721E and J7200. The
ESM error pin output is routed to the PMIC (Power Management IC) which
can reset the board. The dts nodes for SoC and PMIC ESM modules are
added (if not already) to enable them.
Gowtham Tammana (6):
arm: dts: k3-j7200: Add Main domain ESM support
arm: dts: k3-j7200-r5-common: Add pmic node for esm
arm: dts: k3-j7200: Add ESM PMIC support for tps659413
j721e_init: initialize ESM support for J7200 SOM
power: pmic: tps65491: Dont fail on master node
configs: j7200_evm_r5_defconfig: Enable ESM modules
Tero Kristo (2):
arm: mach-k3: j721e_init: initialize ESM support
arm: dts: k3-k721e: Add Main domain ESM support
.../k3-j7200-common-proc-board-u-boot.dtsi | 4 +++
arch/arm/dts/k3-j7200-main.dtsi | 6 +++++
.../k3-j7200-r5-common-proc-board-u-boot.dtsi | 11 ++++++++
.../arm/dts/k3-j7200-r5-common-proc-board.dts | 13 +++++++---
arch/arm/dts/k3-j7200.dtsi | 1 +
arch/arm/dts/k3-j721e.dtsi | 1 +
arch/arm/mach-k3/j721e_init.c | 25 ++++++++++++++++++-
configs/j7200_evm_r5_defconfig | 2 ++
drivers/power/pmic/tps65941.c | 1 -
9 files changed, 59 insertions(+), 5 deletions(-)
create mode 100644 arch/arm/dts/k3-j7200-r5-common-proc-board-u-boot.dtsi
I know Praneeth and Andrew have already commented internally, I just
wanted to summarize publicly
Thank you for sending this out! Unfortunately some of these dt node
updates where never sent to the kernel. We'll need to get these merged
over there so it will be a simple copy/paste once they make it to a
linux tag.
Though I guess we can treat the dt updates as a DONOTMERGE
Thanks for summarising! However I'm inclined to send a v2 of this patch
series here without using board and SoC dts and using only -u-boot.dtsi
since I do not think ESM support will be needed in the kernel at any
point. What do you think?
~Bryan
--
Thanking You
Neha Malcom Francis
