This series fixes eMMC HS400 modes on RK3568 and add support for RK3588. It has been tested with rock-3a-rk3568/rock5b-rk3588 defconfig and
CONFIG_MMC_HS200_SUPPORT=y CONFIG_MMC_HS400_SUPPORT=y CONFIG_MMC_HS400_ES_SUPPORT=y CONFIG_MMC_SPEED_MODE_SET=y using the following command to switch mode and then read 512 MiB of data from eMMC into memory, => mmc dev 0 0 <mode> && mmc info && mmc read 10000000 2000 10000 for each of the modes below. 0 = MMC legacy 1 = MMC High Speed (26MHz) 3 = MMC High Speed (52MHz) 4 = MMC DDR52 (52MHz) 10 = HS200 (200MHz) 11 = HS400 (200MHz) 12 = HS400ES (200MHz) All reads have reported OK, prior to this some of these modes worked and others failed. Patch 1-2 fixes an issue with high-speed bit and uhs speed mode field. Patch 3-6 refactors the rk3568 driver to use set_clock and config_dll ops, so that clocks and regs are changed when output clock is disabled. Patch 7-10 continues refactoring and simplification of the driver. Patch 11-12 updates tap and delay values to fix HS400 modes on RK3568. Patch 13-15 adds support for RK3588 to driver and device tree. Patch 16-17 adds workarounds needed to use PIO mode in SPL to successfully load TF-A into SRAM when booting from eMMC on RK3588. Note that this series does not include any change to defconfigs to enable HS200/HS400/HS400ES modes. Changes in v2: - Add Signed-off-by tag and update commit message with a note from where reg-values originates from - Rename quirks to flags - Use driver data for hs200/hs400 txclk tapnum values - Change u-boot,dm-spl to bootph-pre-ram This series require working pinctrl, see [1]. A copy of this series and its dependencies can be found at [2]. [1] https://patchwork.ozlabs.org/project/uboot/patch/20230315153215.389809-1-eugen.hris...@collabora.com/ [2] https://github.com/Kwiboo/u-boot-rockchip/commits/rk35xx-emmc-v2 Jonas Karlman (16): mmc: sdhci: Fix HISPD bit handling for MMC HS 52MHz mode mmc: sdhci: Set UHS Mode Select field for UHS SDR25 mode mmc: rockchip_sdhci: Fix use of device private data mmc: rockchip_sdhci: Remove unneeded emmc_phy_init ops mmc: rockchip_sdhci: Add set_clock and config_dll sdhci_ops mmc: rockchip_sdhci: Use set_clock and config_dll sdhci_ops mmc: rockchip_sdhci: Refactor execute tuning error handling mmc: rockchip_sdhci: Update speed mode controls in set_ios_post mmc: rockchip_sdhci: Remove empty get_phy and set_enhanced_strobe ops mmc: rockchip_sdhci: Rearrange and simplify used regs and flags mmc: rockchip_sdhci: Fix HS400 and HS400ES mode on RK3568 rockchip: rk3568-rock-3a: Enable support for more eMMC modes mmc: rockchip_sdhci: Add support for RK3588 rockchip: rk3588-rock-5b: Include eMMC node in SPL dtb clk: rockchip: rk3588: Add limited TMCLK_EMMC clock support mmc: rockchip_sdhci: Limit number of blocks read in a single command Peter Geis (1): mmc: sdhci: Allow disabling of SDMA in SPL arch/arm/dts/rk3568-rock-3a-u-boot.dtsi | 8 + arch/arm/dts/rk3588-rock-5b-u-boot.dtsi | 12 +- arch/arm/dts/rk3588s-u-boot.dtsi | 4 + configs/rock5b-rk3588_defconfig | 1 + drivers/clk/rockchip/clk_rk3588.c | 2 + drivers/mmc/Kconfig | 8 + drivers/mmc/rockchip_sdhci.c | 309 +++++++++++++----------- drivers/mmc/sdhci.c | 13 +- 8 files changed, 215 insertions(+), 142 deletions(-) -- 2.40.0
