After the commit (SHA1: 7d08ddd09b75e7a3c103cc0d0d3ed700287f268e) some
u-boot specific XEA FEC related properties have been replaced by ones
from the Linux kernel.

To be more specific - XEA board (and imx287 in general) has built L2
switch connected to FEC, which needs some special treatment.

In u-boot it is handled with 'mac0' node, whereas Linux uses dedicated
switch DTS node.

Signed-off-by: Lukasz Majewski <lu...@denx.de>
---

 arch/arm/dts/imx28-xea-u-boot.dtsi | 22 ++++++++++++++++++++++
 1 file changed, 22 insertions(+)

diff --git a/arch/arm/dts/imx28-xea-u-boot.dtsi 
b/arch/arm/dts/imx28-xea-u-boot.dtsi
index 22dd7bc8a8..9f1e261b2f 100644
--- a/arch/arm/dts/imx28-xea-u-boot.dtsi
+++ b/arch/arm/dts/imx28-xea-u-boot.dtsi
@@ -38,12 +38,34 @@
        bootph-pre-ram;
 };
 
+&mac0 {
+       phy-mode = "rmii";
+       pinctrl-names = "default";
+       pinctrl-0 = <&mac0_pins_a>;
+       phy-supply = <&reg_fec_3v3>;
+       phy-reset-gpios = <&gpio2 13 GPIO_ACTIVE_LOW>;
+       phy-reset-duration = <1>;
+       phy-reset-post-delay = <1>;
+       status = "okay";
+
+       fixed-link {
+               speed = <100>;
+               full-duplex;
+       };
+};
+
 &pinctrl {
        /delete-property/ pinctrl-names;
        /delete-property/ pinctrl-0;
        bootph-pre-ram;
 };
 
+&reg_fec_3v3 {
+       gpio = <&gpio0 0 GPIO_ACTIVE_HIGH>;
+       enable-active-high;
+       regulator-boot-on;
+};
+
 &ssp0 {
        bootph-pre-ram;
 };
-- 
2.30.2

Reply via email to