Reviewed-by: Wei Fu <w...@redhat.com>
Signed-off-by: Yixun Lan <d...@gentoo.org>
---
doc/board/index.rst | 1 +
doc/board/thead/index.rst | 9 +++
doc/board/thead/lpi4a.rst | 129 ++++++++++++++++++++++++++++++++++++++
3 files changed, 139 insertions(+)
create mode 100644 doc/board/thead/index.rst
create mode 100644 doc/board/thead/lpi4a.rst
diff --git a/doc/board/index.rst b/doc/board/index.rst
index 9ef25b1091..aadc90af89 100644
--- a/doc/board/index.rst
+++ b/doc/board/index.rst
@@ -45,6 +45,7 @@ Board-specific doc
starfive/index
ste/index
tbs/index
+ thead/index
ti/index
toradex/index
variscite/index
diff --git a/doc/board/thead/index.rst b/doc/board/thead/index.rst
new file mode 100644
index 0000000000..41566d3a36
--- /dev/null
+++ b/doc/board/thead/index.rst
@@ -0,0 +1,9 @@
+.. SPDX-License-Identifier: GPL-2.0+
+
+T-HEAD
+========
+
+.. toctree::
+ :maxdepth: 1
+
+ lpi4a
diff --git a/doc/board/thead/lpi4a.rst b/doc/board/thead/lpi4a.rst
new file mode 100644
index 0000000000..e395c6ae12
--- /dev/null
+++ b/doc/board/thead/lpi4a.rst
@@ -0,0 +1,129 @@
+.. SPDX-License-Identifier: GPL-2.0+
+
+Sipeed's Lichee PI 4A based on T-HEAD TH1520 SoC
+================================================
+
+The LicheePi4A is a high-performance RISC-V SBC based on
TH1520(4xC910@1.85GHz),
+comes with 4/8/16 GB RAM, and up to 128GB eMMC, and rich peripherals.
+
+ - SoC T-HEAD TH1520 SoC
+ - System Memory 4GB, 8GB, or 16GB LPDDR4X
+ - Storage eMMC flash with 8/32/128 GB
+ - external microSD slot
+ - Networking 2x Gigabit Ethernet
+ - WiFi+BT
+ - Display HDMI2.0, 4-lane MIPI DSI
+ - Camera 4-lane MIPI CSI + 2x2-lane MIPI CSI
+ - Audio Onboard Speaker, 2xMEMS MIC, 3.5mm headphone jack
+ - USB 4xUSB3.0 Type-A, 1xUSB2.0 Type-C
+ - GPIO 2x10Pin breakout, UART/IIC/SPI
+ - Power DC 12V/2A, POE 5V/2.4A, USB Type-C 5V/2A
+
+TH1520 RISC-V SoC
+-----------------
+
+The TH1520 SoC consist of quad-core RISC-V Xuantie C910 (RV64GCV) processor,
+Xuantie C906 audio DSP, low power Xuantie E902 core, it also integrate
+Imagination GPU for graphics, and 4 TOPS NPU for AI acceleration.
+
+Mainline support
+----------------
+
+The support for following drivers are already enabled:
+
+1. ns16550 UART Driver.
+
+Building
+~~~~~~~~
+
+1. Add the RISC-V toolchain to your PATH.
+2. Setup ARCH & cross compilation environment variable:
+
+.. code-block:: none
+
+ export CROSS_COMPILE=<riscv64 toolchain prefix>
+
+The U-Boot is capable of running in M-Mode, so we can directly build it.
+
+.. code-block:: console
+
+ cd <U-Boot-dir>
+ make th1520_lpi4a_defconfig
+ make
+
+This will generate u-boot-dtb.bin
+
+Booting
+~~~~~~~
+
+Currently, we rely on vendor u-boot to initialize the clock, pinctrl subsystem,
+and chain load the mainline u-boot image either via tftp or emmc storage,
+then bootup from it.
+
+Sample boot log from Lichee PI 4A board via tftp
+~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
+
+.. code-block:: none
+
+ brom_ver 8
+ [APP][E] protocol_connect failed, exit.
+
+ U-Boot SPL 2020.01-00016-g8c870a6be8 (May 20 2023 - 01:04:49 +0000)
+ FM[1] lpddr4x dualrank freq=3733 64bit dbi_off=n sdram init
+ ddr initialized, jump to uboot
+ image has no header
+
+
+ U-Boot 2020.01-00016-g8c870a6be8 (May 20 2023 - 01:04:49 +0000)
+
+ CPU: rv64imafdcvsu
+ Model: T-HEAD c910 light
+ DRAM: 8 GiB
+ C910 CPU FREQ: 750MHz
+ AHB2_CPUSYS_HCLK FREQ: 250MHz
+ AHB3_CPUSYS_PCLK FREQ: 125MHz
+ PERISYS_AHB_HCLK FREQ: 250MHz
+ PERISYS_APB_PCLK FREQ: 62MHz
+ GMAC PLL POSTDIV FREQ: 1000MHZ
+ DPU0 PLL POSTDIV FREQ: 1188MHZ
+ DPU1 PLL POSTDIV FREQ: 1188MHZ
+ MMC: sdhci@ffe7080000: 0, sd@ffe7090000: 1
+ Loading Environment from MMC... OK
+ Error reading output register
+ Warning: cannot get lcd-en GPIO
+ LCD panel cannot be found : -121
+ splash screen startup cost 16 ms
+ In: serial
+ Out: serial
+ Err: serial
+ Net:
+ Warning: ethernet@ffe7070000 using MAC address from ROM
+ eth0: ethernet@ffe7070000ethernet@ffe7070000:0 is connected to
ethernet@ffe7070000. Reconnecting to ethernet@ffe7060000
+
+ Warning: ethernet@ffe7060000 (eth1) using random MAC address -
42:25:d4:16:5f:fc
+ , eth1: ethernet@ffe7060000
+ Hit any key to stop autoboot: 2
+ ethernet@ffe7060000 Waiting for PHY auto negotiation to complete.. done
+ Speed: 1000, full duplex
+ Using ethernet@ffe7070000 device
+ TFTP from server 192.168.8.50; our IP address is 192.168.8.45
+ Filename 'u-boot-dtb.bin'.
+ Load address: 0x1c00000
+ Loading: * #########################
+ 8 MiB/s
+ done
+ Bytes transferred = 376686 (5bf6e hex)
+ ## Starting application at 0x01C00000 ...
+
+ U-Boot 2023.07-rc2-00004-g1befbe31c1 (May 23 2023 - 18:40:01 +0800)
+
+ CPU: rv64imafdc
+ Model: Sipeed Lichee Pi 4A
+ DRAM: 8 GiB
+ Core: 13 devices, 6 uclasses, devicetree: separate
+ Loading Environment from <NULL>... OK
+ In: serial@ffe7014000
+ Out: serial@ffe7014000
+ Err: serial@ffe7014000
+ Model: Sipeed Lichee Pi 4A
+ LPI4A=>
--
2.39.3
