The original logic in enumerating all the protocols accidentally
modifies a *loop* variable, node, at Voltage domain protocol.
So subsequent protocol nodes in a device tree won't be detected.
Signed-off-by: AKASHI Takahiro <takahiro.aka...@linaro.org>
---
drivers/firmware/scmi/scmi_agent-uclass.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/firmware/scmi/scmi_agent-uclass.c
b/drivers/firmware/scmi/scmi_agent-uclass.c
index 46a2933d51a4..79584c00a066 100644
--- a/drivers/firmware/scmi/scmi_agent-uclass.c
+++ b/drivers/firmware/scmi/scmi_agent-uclass.c
@@ -422,8 +422,11 @@ static int scmi_bind_protocols(struct udevice *dev)
case SCMI_PROTOCOL_ID_VOLTAGE_DOMAIN:
if (IS_ENABLED(CONFIG_DM_REGULATOR_SCMI) &&
scmi_protocol_is_supported(dev, protocol_id)) {
- node = ofnode_find_subnode(node, "regulators");
- if (!ofnode_valid(node)) {
+ ofnode sub_node;
+
+ sub_node = ofnode_find_subnode(node,
+ "regulators");
+ if (!ofnode_valid(sub_node)) {
dev_err(dev, "no regulators node\n");
return -ENXIO;
}
--
2.34.1
