When debugging, one sometimes only gets partial output lines or nothing at all from the last printf, because the uart has a largish buffer, and the code after the printf() may cause the CPU to hang before the uart IP has time to actually emit all the characters. That can be very confusing, because one doesn't then know exactly where the hang happens.
Introduce a config knob allowing one to wait for the uart fifo to drain whenever a newline character is printed, roughly corresponding to the effect of setvbuf(..., _IOLBF, ...) in ordinary C programs. Signed-off-by: Rasmus Villemoes <rasmus.villem...@prevas.dk> --- common/Kconfig | 11 +++++++++++ drivers/serial/serial-uclass.c | 8 ++++++-- 2 files changed, 17 insertions(+), 2 deletions(-) diff --git a/common/Kconfig b/common/Kconfig index cdb77a6a7d..49130f2a2b 100644 --- a/common/Kconfig +++ b/common/Kconfig @@ -224,6 +224,17 @@ config CONSOLE_FLUSH_SUPPORT help This enables compilation of flush() function for console flush support. +config CONSOLE_FLUSH_ON_NEWLINE + bool "Flush console buffer on every newline character" + depends on CONSOLE_FLUSH_SUPPORT + depends on DM_SERIAL + help + This makes the serial core code flush the console device + whenever a newline (\n) character has been emitted. This can + be especially useful when "printf debugging", as otherwise + lots of output could still be in the UART's FIFO by the time + one hits the code which causes the CPU to hang or reset. + config CONSOLE_MUX bool "Enable console multiplexing" default y if VIDEO || LCD diff --git a/drivers/serial/serial-uclass.c b/drivers/serial/serial-uclass.c index 2f75ff878c..b41e3ebe7f 100644 --- a/drivers/serial/serial-uclass.c +++ b/drivers/serial/serial-uclass.c @@ -181,7 +181,6 @@ int serial_initialize(void) return serial_init(); } -#ifdef CONFIG_CONSOLE_FLUSH_SUPPORT static void _serial_flush(struct udevice *dev) { struct dm_serial_ops *ops = serial_get_ops(dev); @@ -191,7 +190,6 @@ static void _serial_flush(struct udevice *dev) while (ops->pending(dev, false) > 0) ; } -#endif static void _serial_putc(struct udevice *dev, char ch) { @@ -204,6 +202,9 @@ static void _serial_putc(struct udevice *dev, char ch) do { err = ops->putc(dev, ch); } while (err == -EAGAIN); + + if (IS_ENABLED(CONSOLE_FLUSH_ON_NEWLINE) && ch == '\n') + _serial_flush(dev); } static int __serial_puts(struct udevice *dev, const char *str, size_t len) @@ -242,6 +243,9 @@ static void _serial_puts(struct udevice *dev, const char *str) if (*newline && __serial_puts(dev, "\r\n", 2)) return; + if (IS_ENABLED(CONSOLE_FLUSH_ON_NEWLINE) && *newline) + _serial_flush(dev); + str += len + !!*newline; } while (*str); } -- 2.37.2