[PATCH 03/15] board: ti: j721e: evm: Drop board check for ESM

[Nishanth Menon]

When config is enabled, the esm dt probe makes sense. Simplify by
dropping board specific checks.

Signed-off-by: Nishanth Menon <n...@ti.com>
---
 board/ti/j721e/evm.c | 10 ++--------
 1 file changed, 2 insertions(+), 8 deletions(-)

diff --git a/board/ti/j721e/evm.c b/board/ti/j721e/evm.c
index d4f7c1d9f938..75d51a0552c4 100644
--- a/board/ti/j721e/evm.c
+++ b/board/ti/j721e/evm.c
@@ -531,10 +531,8 @@ err_free_gpio:
 
 void spl_board_init(void)
 {
-#if defined(CONFIG_ESM_K3) || defined(CONFIG_ESM_PMIC)
        struct udevice *dev;
        int ret;
-#endif
 
        if ((IS_ENABLED(CONFIG_TARGET_J721E_A72_EVM) ||
             IS_ENABLED(CONFIG_TARGET_J7200_A72_EVM)) &&
@@ -543,24 +541,20 @@ void spl_board_init(void)
                        probe_daughtercards();
        }
 
-#ifdef CONFIG_ESM_K3
-       if (board_ti_k3_is("J721EX-PM2-SOM")) {
+       if (IS_ENABLED(CONFIG_ESM_K3)) {
                ret = uclass_get_device_by_driver(UCLASS_MISC,
                                                  DM_DRIVER_GET(k3_esm), &dev);
                if (ret)
                        printf("ESM init failed: %d\n", ret);
        }
-#endif
 
-#ifdef CONFIG_ESM_PMIC
-       if (board_ti_k3_is("J721EX-PM2-SOM")) {
+       if (IS_ENABLED(CONFIG_ESM_PMIC)) {
                ret = uclass_get_device_by_driver(UCLASS_MISC,
                                                  DM_DRIVER_GET(pmic_esm),
                                                  &dev);
                if (ret)
                        printf("ESM PMIC init failed: %d\n", ret);
        }
-#endif
        if ((IS_ENABLED(CONFIG_TARGET_J7200_A72_EVM) || 
IS_ENABLED(CONFIG_TARGET_J721E_A72_EVM)) &&
            IS_ENABLED(CONFIG_HBMC_AM654)) {
                struct udevice *dev;
-- 
2.40.0