On Thu, Jan 4, 2024 at 12:02 PM Maxim Uvarov <maxim.uva...@linaro.org> wrote:
> CI tests this in all qemu emulated boards. I tested it locally on Raspberry > Pi - works well. This version did not > yet tested on imx8, but the previous version worked on eth0, did not work on > eth1. So I plan to continue testing > these patches on different boards. But in general it's the upper layer then > drivers and theoretically has to work on any > board. But in fact different boards work in different ways and behaviour is > different with their qemu model. So I'm a little bit confused > how to test and debug these patches on board which I don't have physical > access... Can you try to get access to any i.MX board via Linaro? > that is really strange, after reboot you should get the initial stage. > You can type 'lwip list' and 'net list' to check if there is an IP address for > active device set. Nothing strange there: u-boot=> lwip list 1: eth0 UP IP: 192.168.0.122/255.255.255.0, GW: 192.168.0.1, 00:04:9f:06:33:d3 done. u-boot=> net list eth0 : ethernet@30be0000 00:04:9f:06:12:98 active