Hi Jesse,
On 01/02/24 16:00, Jesse Taube wrote:
Add documentation for imxrt1170-evk.
Signed-off-by: Jesse Taube <mr.bossman...@gmail.com>
looks good to me
Reviewed-by: Giulio Benetti <giulio.bene...@benettiengineering.com>
Best regards
--
Giulio Benetti
CEO&CTO@Benetti Engineering sas
---
doc/board/nxp/imxrt1170-evk.rst | 42 +++++++++++++++++++++++++++++++++
1 file changed, 42 insertions(+)
create mode 100644 doc/board/nxp/imxrt1170-evk.rst
diff --git a/doc/board/nxp/imxrt1170-evk.rst b/doc/board/nxp/imxrt1170-evk.rst
new file mode 100644
index 0000000000..4acccdcc93
--- /dev/null
+++ b/doc/board/nxp/imxrt1170-evk.rst
@@ -0,0 +1,42 @@
+.. SPDX-License-Identifier: GPL-2.0+
+
+imxrt1170-evk
+=============
+
+How to use U-Boot on NXP i.MXRT1170 EVK
+---------------------------------------
+
+- Build U-Boot for i.MXRT1170 EVK:
+
+.. code-block:: bash
+
+ $ make mrproper
+ $ make imxrt1170-evk_defconfig
+ $ make
+
+This will generate the SPL image called SPL and the u-boot.img.
+
+- Flash the SPL image into the micro SD card:
+
+.. code-block:: bash
+
+ $sudo dd if=SPL of=/dev/sdX bs=1k seek=1 conv=notrunc; sync
+
+- Flash the u-boot.img image into the micro SD card:
+
+.. code-block:: bash
+
+ $sudo dd if=u-boot.img of=/dev/sdX bs=1k seek=128 conv=notrunc; sync
+
+- Jumper settings::
+
+ SW1: 1 0 1 0
+ SW2: 0 0 0 0 0 0 0 0 1 0 0 0
+
+where 0 means bottom position and 1 means top position (from the
+switch label numbers reference).
+
+- Connect the USB cable between the EVK and the PC for the console.
+ The USB console connector is the one close the ethernet connector
+
+- Insert the micro SD card in the board, power it up and U-Boot messages
should come up.
