>From the current documentation it is not entirely obvious where to take
some of the u-boot build artifacts in order to flash them to the sd
card. Extend the "Program the SD card" block by providing relative paths
to the jh7110-starfive-visionfive-2.dtb and u-boot-spl.bin.normal.out
files.
Add "$(linux_image_dir)/" prefix to the Image.gz and initramfs.cpio.gz
files in order to provide some information about where they could be
taken from.
Signed-off-by: Ivan Orlov <ivan.orlov0...@gmail.com>
---
doc/board/starfive/visionfive2.rst | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/doc/board/starfive/visionfive2.rst
b/doc/board/starfive/visionfive2.rst
index abda8ac21b..031d66fbfb 100644
--- a/doc/board/starfive/visionfive2.rst
+++ b/doc/board/starfive/visionfive2.rst
@@ -103,15 +103,15 @@ Program the SD card
.. code-block:: bash
- sudo dd if=u-boot-spl.bin.normal.out of=/dev/sdb1
+ sudo dd if=spl/u-boot-spl.bin.normal.out of=/dev/sdb1
sudo dd if=u-boot.itb of=/dev/sdb2
sudo mount /dev/sdb3 /mnt/
- sudo cp u-boot-spl.bin.normal.out /mnt/
+ sudo cp spl/u-boot-spl.bin.normal.out /mnt/
sudo cp u-boot.itb /mnt/
- sudo cp Image.gz /mnt/
- sudo cp initramfs.cpio.gz /mnt/
- sudo cp jh7110-starfive-visionfive-2.dtb /mnt/
+ sudo cp $(linux_image_dir)/Image.gz /mnt/
+ sudo cp $(linux_image_dir)/initramfs.cpio.gz /mnt/
+ sudo cp arch/riscv/dts/jh7110-starfive-visionfive-2.dtb /mnt/
sudo umount /mnt
Booting
--
2.34.1
