------------------------------------------------------------
> The command is very useful.
> I would like to have also the ONFI timing mode printed for nand-flash
> 😊
As far as I can see the actually set mode is not stored anywhere. One could
print it after it was successfully set, but that would be in nand base, not in
the atmel driver.
OK. Understood.
Thanks.
> Also I recommend to print the master clock in MHz, and to print the master
> clock name/label from ccf driver:
> https://github.com/u-boot/u-boot/blob/master/drivers/clk/at91/sama7g5.
> c#L410
Should be possible. I could do this and send a v2?
Yes Please 😊
Also please note that older SAM9/SAMA5 series have no ccf drivers ☹
Only SAM9X6+ and SAMA7 series have ccf 😊
Thanks.
Greets
Alex
>
> Tested-by: Mihai Sain <mihai.s...@microchip.com>
>
> Best regards,
> Mihai Sain
