On Mon, Jun 3, 2024 at 1:18 AM Christian Loehle <christian.loe...@arm.com> wrote: > > On 5/31/24 21:47, Tim Harvey wrote: > > Greetings, > > > > I'm seeing an issue on an imx8mm board (imx8mm-venice-gw73xx) where > > for a specific set of microsd cards if I have accessed the microsd in > > U-Boot with UHS/1.8V the kernel will not recognize that microsd when > > scanning. > > > > The issue does not occur with all microsd cards but seems to appear > > with a large sample size of a specific card/model (Kingston SDC32 32GB > > SDR104 card). I do not see a signal integrity issue on the scope. > > > > Instrumenting the kernel the issue is that the host reports a CRC > > error as soon as the first mmc_send_if_cond call which occurs in > > mmc_rescan_try_freq. > > > > I can avoid the issue by either not accessing the microsd in U-Boot or > > by disabling UHS/1.8V mode in U-Boot therefore what I think is > > happening is that U-Boot leaves the card in UHS/1.8V signalling mode > > and when the kernel scans it sets the voltage back to 3.3V > > standard/default and default timings then issues its clock cycles to > > 'reset' the card and the card does not recognize the reset. I'm > > wondering if this is because the reset is done via clock cycles after > > the kernel has set the I/O voltage back to 3.3V when perhaps the card > > is still in 1.8V mode (although I don't see how that would cause an > > issue)? > > It will cause an issue for many cards and might break some cards. > > > > > Is there some sort of MMC 'reset' I can/should do in U-Boot before > > booting the kernel? Has anyone encountered anything like this before? > > There is no 'switching back' to 3.3V signalling from UHS 1.8V. > The only way this can be done is therefore a full power-off. > Is that done correctly for your system? > AFAIR spec dictates 500ms of <0.5V on VCC. Note that driving CLK/signal > lines can also sustain the card somewhat, as leakage is only limited > within operating voltage.
Hi Christian, Are you saying the only way to properly reset from 1.8V is to have a VDD supply on the microSD card that can be turned off before booting to Linux? We have never had that before and never encountered something like this. Best Regards, Tim
