From: Lukas Funke <lukas.fu...@weidmueller.com>
This commit enables SPL to reset the CPU via PMU-firmware. The usual
reset mechanism requires bl31 to be loaded which may not be the case in
SPL.
Signed-off-by: Lukas Funke <lukas.fu...@weidmueller.com>
---
Changes in v2:
- Drop 2/2 since reworking ZYNQMP_FIRMWARE dependency is out-of-scope
board/xilinx/zynqmp/zynqmp.c | 9 +++++++++
1 file changed, 9 insertions(+)
diff --git a/board/xilinx/zynqmp/zynqmp.c b/board/xilinx/zynqmp/zynqmp.c
index f370fb7347a..a129b1dbbbc 100644
--- a/board/xilinx/zynqmp/zynqmp.c
+++ b/board/xilinx/zynqmp/zynqmp.c
@@ -40,6 +40,7 @@
#include <linux/bitops.h>
#include <linux/delay.h>
#include <linux/sizes.h>
+#include <dt-bindings/reset/xlnx-zynqmp-resets.h>
#include "../common/board.h"
#include "pm_cfg_obj.h"
@@ -285,6 +286,14 @@ int dram_init(void)
#if !CONFIG_IS_ENABLED(SYSRESET)
void reset_cpu(void)
{
+ if (!IS_ENABLED(CONFIG_ZYNQMP_FIRMWARE)) {
+ log_warning("reset failed: ZYNQMP_FIRMWARE disabled");
+ return;
+ }
+
+ xilinx_pm_request(PM_RESET_ASSERT,
+ ZYNQMP_PM_RESET_START + ZYNQMP_RESET_SOFT,
+ PM_RESET_ACTION_ASSERT, 0, 0, NULL);
}
#endif
--
2.30.2
