On Thursday 05 May 2011 16:08:35 Steven A. Falco wrote: > APM errata CHIP_21 for the 405EX/EXr (from the rev 1.09 document dated > 4/27/11) states that rev D processors may wake up with the wrong feature > set. This patch implements the APM-proposed workaround. > > To enable this patch for your board, add the appropriate define for your > CPU to your board header file. See kilauea.h for more information. The > following variants are supported: > > #define CONFIG_SYS_4xx_CHIP_21_405EX_NO_SECURITY > #define CONFIG_SYS_4xx_CHIP_21_405EX_SECURITY > #define CONFIG_SYS_4xx_CHIP_21_405EXr_NO_SECURITY > #define CONFIG_SYS_4xx_CHIP_21_405EXr_SECURITY > > Please note that if you select the wrong define, your board will not > boot, and JTAG will be required to recover. > > Tested on custom boards using: > > CONFIG_SYS_4xx_CHIP_21_405EX_NO_SECURITY <sfa...@harris.com> > CONFIG_SYS_4xx_CHIP_21_405EX_SECURITY <eib...@gdsys.de> > > Signed-off-by: Steve Falco <sfa...@harris.com> > Acked-by: Dirk Eibach <eib...@gdsys.de>
checkpatch has some minor problems with your patch: checkpatch.pl patches_misc/\[U-Boot\]\ \[PATCH\ v3\]\ PPC405EX\ CHIP_21\ erratum.mbox ERROR: Invalid UTF-8, patch and commit message should be encoded in UTF-8 #122: FILE: arch/powerpc/cpu/ppc4xx/cpu_init.c:241: + * SDR0_ECID3[12:15] is different from PVR[28:31], then � processor is ^ ERROR: Invalid UTF-8, patch and commit message should be encoded in UTF-8 #124: FILE: arch/powerpc/cpu/ppc4xx/cpu_init.c:243: + * required). else � go to step 3. ^ ERROR: Invalid UTF-8, patch and commit message should be encoded in UTF-8 #127: FILE: arch/powerpc/cpu/ppc4xx/cpu_init.c:246: + * SDR0_ECID3[10:11] matches its expected value, then � continue ^ ERROR: Invalid UTF-8, patch and commit message should be encoded in UTF-8 #128: FILE: arch/powerpc/cpu/ppc4xx/cpu_init.c:247: + * executing initialization code, no reset required. else � write ^ total: 4 errors, 0 warnings, 144 lines checked No need to resend, I fixed this manually. Applied to u-boot-ppc4xx/master. Thanks. Best regards, Stefan -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: off...@denx.de _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot