On Thu, Jan 15, 2026 at 05:01:35PM -0600, Chris Morgan wrote: > From: Chris Morgan <[email protected]> > > According to Synopsys Databook, we shouldn't be > relying on GCTL.CORESOFTRESET bit as that's only for > debugging purposes. Instead, let's use DCTL.CSFTRST > if we're OTG or PERIPHERAL mode. > > Host side block will be reset by XHCI driver if > necessary. Note that this reduces amount of time > spent on dwc3_probe() by a long margin. > > We're still gonna wait for reset to finish for a > long time (default to 1ms max), but tests show that > the reset polling loop executed at most 19 times > (modprobe dwc3 && modprobe -r dwc3 executed 1000 > times in a row). > > Note that this patch was submitted to Linux in 2016 [1], however I can > confirm it is needed to support gadget mode in U-Boot on my device. > While I am referencing this patch from Linux I am in fact taking the > full existing dwc3_core_soft_reset() function from Linux as it exists > in v6.19-rc5, so it may differ slightly from the information in the > 2016 patch. > > [1] > https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/patch/drivers/usb/dwc3?id=f59dcab176293b646e1358144c93c58c3cda2813 >
Hi Chris, Thanks for your work here. We also have issues with gadget mode on the iMX95 DWC3 IP, noticed on our Aquila iMX95 SoM. This patch series fixes our issues, but only with a small change: > - mdelay(100); > + dev_warn(dwc->dev, "DWC3 controller soft reset failed.\n"); > + return -ETIMEDOUT; > > - /* After PHYs are stable we can take Core out of reset state */ > - reg = dwc3_readl(dwc->regs, DWC3_GCTL); > - reg &= ~DWC3_GCTL_CORESOFTRESET; > - dwc3_writel(dwc->regs, DWC3_GCTL, reg); > +done: > + /* > + * For DWC_usb31 controller 1.80a and prior, once DCTL.CSFRST bit > + * is cleared, we must wait at least 50ms before accessing the PHY > + * domain (synchronization delay). > + */ > + if (DWC3_VER_IS_WITHIN(DWC31, ANY, 180A)) > + mdelay(50); On the iMX95 I also need this delay to get everything functional. If I remove the conditional version check here, it works well. 'dwc->revision' is 0x5533330B. Is anyone aware of the DWC3 requirements on the iMX95? Thanks and kind regards, Ernest
