Depending on the phase selection (single or multi), the FPWM bits
configured forces the regulator to operate in PWM mode. In case of
multi-phase selection, the FPWM_MP bits enforce the regulator to also
operate in multi-phase. This fixes correct multi-phase operation.

Fixes: 065a452ae6a1 ("power: regulator: tps65941: add regulator support")
Link: https://www.ti.com/lit/ds/symlink/tps6594-q1.pdf
Signed-off-by: Keerthy <[email protected]>
Signed-off-by: Takuma Fujiwara <[email protected]>
Signed-off-by: Neha Malcom Francis <[email protected]>
---
Tested on J721S2-EVM

https://gist.github.com/nehamalcom/a74fb2a3b59421d0e04693c7d244fdb4

Before the patch, the kernel TPS6594 regulator driver would warn about
overcurrent on a buck, this was due to incorrect multi-phase configuration.
This patch resolves it.

 drivers/power/regulator/tps65941_regulator.c | 13 ++++++++++---
 include/power/tps65941.h                     |  2 ++
 2 files changed, 12 insertions(+), 3 deletions(-)

diff --git a/drivers/power/regulator/tps65941_regulator.c 
b/drivers/power/regulator/tps65941_regulator.c
index 2561d6f4c6c..e0297302914 100644
--- a/drivers/power/regulator/tps65941_regulator.c
+++ b/drivers/power/regulator/tps65941_regulator.c
@@ -63,13 +63,14 @@ static inline int tps65941_get_chip_id(struct udevice *dev)
 
 static int tps65941_buck_enable(struct udevice *dev, int op, bool *enable)
 {
-       int ret;
+       int ret, idx;
        unsigned int adr;
        struct dm_regulator_uclass_plat *uc_pdata;
 
        uc_pdata = dev_get_uclass_plat(dev);
        adr = uc_pdata->ctrl_reg;
 
+       idx = dev->driver_data;
        ret = pmic_reg_read(dev->parent, adr);
        if (ret < 0)
                return ret;
@@ -84,10 +85,16 @@ static int tps65941_buck_enable(struct udevice *dev, int 
op, bool *enable)
 
                return 0;
        } else if (op == PMIC_OP_SET) {
-               if (*enable)
+               if (*enable) {
                        ret |= TPS65941_BUCK_MODE_MASK;
-               else
+                       /* Enable FPWM */
+                       ret |= TPS65941_BUCK_FPWM_MASK;
+                       /* If Multiphase enable FPWM_MP */
+                       if (idx == 12 || idx == 123 || idx == 1234)
+                               ret |= TPS65941_BUCK_FPWM_MP_MASK;
+               } else {
                        ret &= ~TPS65941_BUCK_MODE_MASK;
+               }
                ret = pmic_reg_write(dev->parent, adr, ret);
                if (ret)
                        return ret;
diff --git a/include/power/tps65941.h b/include/power/tps65941.h
index a026ec56958..a8b1044b2f9 100644
--- a/include/power/tps65941.h
+++ b/include/power/tps65941.h
@@ -20,6 +20,8 @@
 #define TPS65941_BUCK_VOLT_MAX_HEX     0xFF
 #define TPS65941_BUCK_VOLT_MAX         3340000
 #define TPS65941_BUCK_MODE_MASK                0x1
+#define TPS65941_BUCK_FPWM_MASK                0x2
+#define TPS65941_BUCK_FPWM_MP_MASK     0x4
 
 #define TPS65941_LDO_VOLT_MASK         0x7E
 #define TPS65941_LDO_VOLT_MAX_HEX      0x3A
-- 
2.34.1

Reply via email to