From: Nagabhushana Netagunte <nagabhushana.netagu...@ti.com>

TX and RX channel numbers programmed as '1' during EMAC
teardown initialization is wrong. This patch fixes the
same by setting channel number to '0' which is used by U-boot.

Signed-off-by: Sugumar Natarajan <sugu...@ti.com>
Signed-off-by: Nagabhushana Netagunte <nagabhushana.netagu...@ti.com>
---
 drivers/net/davinci_emac.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/davinci_emac.c b/drivers/net/davinci_emac.c
index 66c0d13..c0b8929 100644
--- a/drivers/net/davinci_emac.c
+++ b/drivers/net/davinci_emac.c
@@ -457,7 +457,7 @@ static void davinci_eth_ch_teardown(int ch)
 
        if (ch == EMAC_CH_TX) {
                /* Init TX channel teardown */
-               writel(1, &adap_emac->TXTEARDOWN);
+               writel(0, &adap_emac->TXTEARDOWN);
                do {
                        /*
                         * Wait here for Tx teardown completion interrupt to
@@ -476,7 +476,7 @@ static void davinci_eth_ch_teardown(int ch)
                writel(0, &adap_emac->TX0HDP);
        } else {
                /* Init RX channel teardown */
-               writel(1, &adap_emac->RXTEARDOWN);
+               writel(0, &adap_emac->RXTEARDOWN);
                do {
                        /*
                         * Wait here for Rx teardown completion interrupt to
-- 
1.6.2.4

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to